3
►
► use tap water or water with any biological components, minerals
these
Damage caused by impurity build
►
the manual for future reference.
►
1.
2.
and let water pass through while bleeding (if the unit is a controller
page 10 of the
3. Try not to get any water in-between the black electronics case and
these seams.
4. Tighten up both bleed screws, and then block the downstream
page 18
page 27
►
►
of standard gas
drop is 2 psig, going all the way to 20 psig drop in certain models.
Please see pages 47 and 49 of the manual.