MICROWAVE SENSOR LAMP HOLDER
Model: PELL0217
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
• When using electrical appliances basic safety precautions should always be
followed.
• Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
• This appliance is intended for indoor use only.
• Do not touch the lamp holder, bulb socket or bulb with wet hands.
OPERATION
• When you switch on the power for the rst time, the controlled load and connected
lamp will light in timer setting state, between 15-300 seconds (according to your
TIME setting).
• Following this, the lamp holder will resume normal working state.
• The controlled load and lamp only work in low light conditions (less than 3LUX).
• Setting must be done in darkness (less than 3LUX), otherwise the sensor lamp will
not work.
• Adjust the TIME control anti-clockwise to the minimum (-), turn the SENSOR knob
clockwise to the maximum (+) sensitivity and detection range initially then adjust
each in turn to your required duration and sensitivity.
• Use only with screw base, bare bulb light socket.
• Only install in well ventilated spaces away from heat sources.
• Avoid strong sunlight, or damp environments.
CLEANING & STORAGE
• Before cleaning, disconnect from the mains power supply.
• Use a soft cloth to wipe o any dust. If the lamp holder is very dirty, use a lightly
moistened cloth then wipe dry. Do not use chemicals that may damage the casing.
TECHNICAL SPECIFICATION
Mains voltage 220-240V~ 50Hz
Motion Detection Range 3-7m 360 degrees (radius)
Time Delay 15 sec to 5 mins (adjustable)
Lamp type E27
Installation Height 2 - 3.5 metres
Transmitter frequency 2.8GHz
Dimensions 68 x 68 x 108mm
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling of the
materials used. Contact your local authority for details of recycling schemes in your area.
Made in China.
PR2 9PP
PO Box 13362 Dublin 2
Man Rev 1.1
/
