2. Honda
  3. 08F52-TG7-100

Honda 08F52-TG7-100 Installation guide

  • Hello! I'm a chat assistant, and I've reviewed the installation instructions for the Honda Tailgate Chrome Trim 08F52-TG7-100 designed for the 2016 Pilot. This document provides detailed steps for a proper installation, emphasizing the use of adhesive, the need for a rubber roller, and the recommended ambient temperature for installation. I'm ready to assist you with any questions you may have about this product and how to install it according to the recommendations.
  • What is the recommended ambient temperature for installation?
    How long should I wait before washing the vehicle after installation?
    Who should install this trim?
Publications No.
Issue Date
INSTALLATION
INSTRUCTIONS
Accessory Application
© 2015 American Honda Motor Co., Inc. – All Rights Reserved. AII01913-18 (1506) 1of2
08F52-TG7-1000-90
VERSION 1
TAILGATE CHROME TRIM
P/N 08F52-TG7-100 2016 PILOT
JUN 2015
PARTS LIST
Tailgate chrome trim
Alcohol swab
TOOLS AND SUPPLIES REQUIRED
Masking tape
The following tool is available through the Honda Tool and
Equipment Program. On the iN, click on: Service >
Service Bay > Tool and Equipment Program, then enter
the number under “Search”. Or, call 888-424-6857.
• Rubber Roller (T/N MHLE54D)
Illustration of the Tailgate Chrome Trim on the Vehicle
TAILGATE
CHROME
TRIM
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
NOTE:
• Do not damage the paint finish.
• This kit should be installed only if the ambient air
temperature is 15°C (60°F) or above.
• To allow the adhesive to cure, do not wash the vehicle
for 24 hours. Please advise the customer.
1. Using one alcohol swab, thoroughly clean the area
where the tailgate chrome trim will attach.
ALCOHOL
SWAB
Clean with an
alcohol swab. TAILGATE
2of2 AII01913-18 (1506) © 2015 American Honda Motor Co., Inc. – All Rights Reserved.
2. Peel back the adhesive backings, and tape them to
the front surface of the tailgate chrome trim with
masking tape. Remove the small piece of adhesive
backings.
MASKING
TAPE
Temporarily
attach.
TAILGATE
CHROME
TRIM
6 ADHESIVE
BACKINGS
(Peel.)
MASKING
TAPE
2 ADHESIVE
BACKINGS
(Remove.)
3. Align and attach the tailgate chrome trim as shown.
TAILGATE
CHROME
TRIM TAILGATE SECTION
VIEW
CURVE
END
TAILGATE
CHROME
TRIM
Equal spacing.
TAILGATE
CHROME
TRIM
TAILGATE
4. While applying light pressure against the tailgate
chrome trim, carefully remove the taped adhesive
backings.
TAILGATE
CHROME
TRIM 6 ADHESIVE
BACKINGS
(Remove.)
TAILGATE
5. Using a rubber roller, apply firm pressure against the
tailgate chrome trim and roll from one end to the
other. Apply firm pressure especially at the ends.
TAILGATE
CHROME
TRIM
RUBBER
ROLLER
TAILGATE
/