Dell PowerEdge C6220 Specification

Installing the LSI 9285 PCIe Card on

Dell PowerEdge C6220 Systems

Follow the procedure in this document to install the LSI 9285 PCIe card on your

Dell PowerEdge C6220 1U node.

CAUTION:

Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your product

documentation, or as directed by the online or telephone service and support team.

Damage due to servicing that is not authorized by Dell is not covered by your warranty.

Read and follow the safety instructions that came with the product.

The following items are available in the PCIe card kit:

• LSI 9285 PCIe card

• rubber jumper

To install the LSI 9285 PCIe card:

1

Turn off the system, including any attached peripherals, and disconnect the

system from the electrical outlet.

2

Open the system.

3

Locate the jumper PCN3 on the system board.

4

Ensure that you place the rubber jumper on pin 2 of the system-board jumper.

For more information see Figure 1.

Figure 1. Installing the Rubber Jumper

5

Install the LSI 9285 PCIe card.

NOTE:

For more information on installing a PCIe card, see the Hardware Owner’s

Manual at dell.com/cloudedgemanuals.

6

Close the system.

7

Reconnect the system to its electrical outlet and turn the system on, including

any attached peripherals.

____________________

Trademarks used in this text: Dell™ and the DELL logo are trademarks of Dell Inc. LSI is a trademark or

registered trademark of LSI Corporation or its subsidiaries.

2013 - 04

1 rubber jumper 2 system-board jumper (PCN3)

1

2

Page is loading ...