iStarUSA EAGE1040TG-PM Owner's manual

EAGE1040TG-PM
iStarUSA
Brand
iStarUSA
Model
EAGE1040TG-PM
Category
Disk arrays
Type
Owner's manual

This manual is also suitable for

EAGE8402TG-ES
EAGE540TG-PM
EAGE1040TG-PM
EAGE4402TG-ES
eSATA Series|EAGE8402TG-ES|EAGE4402TG-ESUser’s Manual
1
EAGE8402TG-ES EAGE4402TG-ES
■ Content
page
1
2
3
4
5
6
7
8
9
2.5” HDD
EAGE8402TG-ES & EAGE4402TG-ES
A. Product Overview -Front
B. Product Overview -Rear
C. Switching Power Supply Voltage
D. Install 2.5” Hard Drive
E. Power ON/OFF System
F. Locking and Unlocking Door
G. Connect to Your Computer
H. iStarUSAcare
3.5” HDD
EAGE1040TG-PM & EAGE540TG-PM
A. Product Overview -Front
B. Product Overview -Rear
C. Switching Power Supply Voltage
D. Install 3.5” Hard Drive
E. Power ON/OFF System
F. Locking and Unlocking Door
G. Connect to Your Computer
H. iStarUSAcare
eSATA Series|EAGE8402TG-ES|EAGE4402TG-ESUser’s Manual
2
1
4
5
6
6
4
8
1
2
3
1
2
3
2
7
7
8
8
7
5
3
POWER LED
HDD ON/OFF SWITCH & LED
KEY LOCK
4
5
6
POWER SWITCH
AC INLET
110V/220V SWTICH
7
8
eSATA CONNECTOR x4
60mm FAN
LED Behavior
Color
Solid Green
POWER LED
System Power ON
System Power OFFOff
Status
Color
Solid Blue
HDD LED
*please note: some of SSDs (Solid-State Drive) do not support access (read/write) signal.
HDD Power ON
Drives Working (Read/Write)Blinking Blue
HDD Power OFFOff
Status
EAGE8402TG-ES EAGE4402TG-ES
EAGE8402TG-ES EAGE4402TG-ES
A
Product Overview - Front
B
Product Overview - Rear
eSATA Series|EAGE8402TG-ES|EAGE4402TG-ESUser’s Manual
3
C
Switching Power Supply Voltage
D
Installing 2.5” Hard Drive
115
230
1. Switch to right voltage setting before turning on power switch
*CAUTION:
Ensure the power supply voltage selector switch is correctly set for
your region before use
Wrong voltage setting will cause damages on devices
1
2
3
1. Pull HDD tray out
2. Install 2.5 HDD onto tray
3. use four M3 screws to secure 2.5” HDD to tray
1. Turn the key clockwise to lock the door
2. Turn the key counterclockwise to unlock the door
*CAUTION:
To prevent drive failures or data loss,
unmount the device in OS before powering off hard disk bay
2
3
2. Tighten two hand screws to secure HDD tray
3. Push individual power buttons to power on each hard drive
4. Push power buttons again to power off hard drives
1. Make sure power switch in the back of chassis is in ON position
1
E
Powering ON/OFF System
F
Locking and Unlocking Door
eSATA Series|EAGE8402TG-ES|EAGE4402TG-ES
4
User’s Manual
G
Connect to Your Computer by eSATA
EAGE8402TG-ES
EAGE4402TG-ES
Raid Control Card
eSATA Cable
eSATA Cable
Eight eSATA cables are required.
Four eSATA cables are required.
*please make sure all the cable connectors are secured (locked) properly.
EAGE8402TG-ES requires controllers with a total of eight
eSATA connectors.
EAGE4402TG-ES requires a controller with four eSATA
connectors.
eSATA Cable
eSATA Cable
G
Connect to Your Computer by miniSAS
EAGE8402TG-ES
EAGE4402TG-ES
Raid Control Card
4 eSATA to SFF-8088 cable
Two SFF-8088 to 4 eSATA cables are required.
one for disk 1~4, second for disk 5~8.
One SFF-8088 to 4 eSATA cable is required.
*please make sure all the cable connectors are secured (locked) properly.
EAGE8402TG-ES requires a controller with two SFF-8088
connectors.
EAGE4402TG-ES requires a controller with one SFF-8088
connector.
4 eSATA to SFF-8088 cable
eSATA Series|EAGE8402TG-ES|EAGE4402TG-ES
5
User’s Manual
H
iStarUSAcare
We will help you navigate our website to find the information that you
need. Go to www.istarusa.com , and click on live chat bubble above the
Search Bar.
Our technicians are standing by to take your questions.
Visit http://istarusa.com/support/ , and you will receive a technical
support ticket to help track your requests from the beginning to the end.
Or you can contact us @888-989-1189
Copyright:
Copyright © 2014 by iStarUSA Global, all rights reserved. No part of this publication may be repro-
duced, transmitted, transcribed, stored in a retrieval system, translated into any language, in any
form or by an means or otherwise, without the prior written permission of iStarUSA Global. 727
Phillips Dr., City of Industry, CA 91748.
iStarUSA Global reserves the right to make modification and additions to this product and manual
without notice or taking any liability.
Disclaimer:
iStarUSA Global assumes no liability for errors or omissions in this document. Nor does iStarUSA
Global make any commitment to update the information contained herein. Pictures in this docu-
ment are for demonstration purpose only and may not be the same as the actual product.
eSATA Series|EAGE1040TG-PM|EAGE540TG-PMUser’s Manual
6
■ Content
page
6
7
8
9
3.5” HDD
EAGE1040TG-PM & EAGE540TG-PM
A. Product Overview -Front
B. Product Overview -Rear
C. Switching Power Supply Voltage
D. Install 3.5” Hard Drive
E. Power ON/OFF System
F. Locking and Unlocking Door
G. Connect to Your Computer
H. iStarUSAcare
EAGE540TG-PMEAGE1040TG-PM
eSATA Series|EAGE1040TG-PM|EAGE540TG-PMUser’s Manual
7
EAGE1040TG-PM EAGE540TG-PM
EAGE1040TG-PM EAGE540TG-PM
1
2
3
1
2
3
POWER LED
HDD ON/OFF SWITCH & LED
KEY LOCK
4
5
6
120mm FAN
eSATA CONNECTOR
POWER SWITCH
7
8
AC INLET
110V/220V SWTICH
LED Behavior
Color
Solid Green
POWER LED
System Power ON
System Power OFFOff
Status
Color
Solid Blue
HDD LED
*please note: some of SSDs (Solid-State Drive) do not support access (read/write) signal.
HDD Power ON
Drives Working (Read/Write)Blinking Blue
HDD Power OFFOff
Status
A
Product Overview - Front
B
Product Overview - Rear
2
3
1
6
4
4
5
5
6
7
7
4
8
8
5
eSATA Series|EAGE1040TG-PM|EAGE540TG-PMUser’s Manual
8
C
Switching Power Supply Voltage
D
Installing 3.5” Hard Drive
E
Powering ON/OFF System
F
Locking and Unlocking Door
1
2 3
1. Pull HDD tray out
2. Install 3.5 HDD onto tray
3. use four #6-32 screws to secure 3.5” HDD to tray
1. Turn the key clockwise to lock the door
2. Turn the key counterclockwise to unlock the door
1. Switch to right voltage setting before turning on power switch
*CAUTION:
Ensure the power supply voltage selector switch is correctly set for
your region before use
Wrong voltage setting will cause damages on devices
115
230
*CAUTION:
To prevent drive failures or data loss,
unmount the device in OS before powering off hard disk bay
2. Tighten two hand screws to secure HDD tray
3. Push individual power buttons to power on each hard drive
4. Push power buttons again to power off hard drives
1. Make sure power switch in the back of chassis is in ON position
3
2
1
eSATA Series|EAGE1040TG-PM|EAGE540TG-PMUser’s Manual
9
G
Connect to Your Computer
H
iStarUSAcare
EAGE1040TG-PM
EAGE540TG-PM
Raid Control Card
eSATA Cable
Two eSATA cables are required.
one for disk 1~5, second for disk 6~10.
One eSATA cable is required.
*please make sure all the cable connectors are secured (locked) properly.
EAGE1040TG-PM requires a controller that supports Port
Multiplier function with two eSATA connectors.
EAGE540TG-PM requires a controller that supports Port
Multiplier function with one eSATA connector.
We will help you navigate our website to find the information that you
need. Go to www.istarusa.com , and click on live chat bubble above the
Search Bar.
Our technicians are standing by to take your questions.
Visit http://istarusa.com/support/ , and you will receive a technical
support ticket to help track your requests from the beginning to the end.
Or you can contact us @888-989-1189
Copyright:
Copyright © 2014 by iStarUSA Global, all rights reserved. No part of this publication may be repro-
duced, transmitted, transcribed, stored in a retrieval system, translated into any language, in any
form or by an means or otherwise, without the prior written permission of iStarUSA Global. 727
Phillips Dr., City of Industry, CA 91748.
iStarUSA Global reserves the right to make modification and additions to this product and manual
without notice or taking any liability.
Disclaimer:
iStarUSA Global assumes no liability for errors or omissions in this document. Nor does iStarUSA
Global make any commitment to update the information contained herein. Pictures in this docu-
ment are for demonstration purpose only and may not be the same as the actual product.
eSATA Cable
eSATA Cable
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

iStarUSA EAGE1040TG-PM Owner's manual

EAGE1040TG-PM
iStarUSA
Brand
iStarUSA
Model
EAGE1040TG-PM
Category
Disk arrays
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents