Other Functions
1. Power-off memory function:
This machine has power-off memory function. In case of abrupt power failure or the power must be cut off during a
program cycle, the present settings will be saved, and operation will resume when the power is switched on again.
2. Display messages:
When the door lock indicator and the working indicator are on:
1 hour 18 minutes left
2 minutes left
Spinning speed 1600rpm
End of program
When the door lock indicator and the working indicator are off:
Delay wash time is 11 h and 58 min, i.e. program starts 11 h and 58 min later.
Delay wash time is1hand18min,i.e.program starts1hand18minlater.
Error message. Door is not properly shut 20s after program is started.
Correction: Shut the door properly. If the error message still exists, please contact the
maintenance personnel.
Error message. Failure to reach the desired water level within 12 min.
Correction: Check to see if the tap is turned on and the water pressure is correct. If error still
exists, contact the maintenance personnel.
Error message. Drainage error, water not emptied within 3 min.
Correction: Clean the filter and check the drain hose for blockage. If error still exists, please contact
the maintenance personnel.
Error message. Water level surpasses the protected level.
Correction: Drainage pump starts to drain. If error still exists next time, contact the maintenance personnel.
Error message. Temperature sensor or heating coil is damaged, or the desired temperature is not met within
the specified time due to an overload of laundry.
Correction: If the program refuses to operate, please contact the maintenance personnel.
Error message. Motor overheat protection or is damaged.
Correction: Contact the maintenance personnel.
Error message. Motor speed error. It may be connected improperly or damaged.
Correction: Contact the maintenance personnel.
Error message. Program controller error.
Correction: Contact the maintenance personnel.
Error message. Overvoltage or undervoltage error.
Correction: Contact the maintenance personnel.
Error message. Thyristor shortcut error.
Correction: Contact the maintenance personnel.
Error message. EEPROM non-protective area write error.
Correction: Contact the maintenance personnel.
Error message. EEPROM non-protective area read error.
Correction: Contact the maintenance personnel.
Error message. EEPROM protective area read error.
3.How to cancel a program and reselect another program during one is running
Turn the programming knob to " " for at least 5 seconds to automatically cancel a program; turn the knob again
to select a new program.
Correction: Contact the maintenance personnel.