Howdens Joinery HCB3483 Operating instructions

Type
Operating instructions

This manual is also suitable for

108
Hob wall cabinet
- Modification for microwave housing
Section 4 - Kitchen installation - Wall cabinets
Hob wall/Half-height wall/Bridging cabinet
Remove the back panel from the unit
discarding staples. Remove the wall fixing rail.
Cabinet fixing
Secure the cabinet to the wall using the suspension brackets.
Secure through the adjoining cabinets and into the hob cabinet for additional fixing.
NOTE: The modified Hob Wall Unit is for the appliance housing.
Hob wall
H394mm
Integrated
microwave
top unit
Extra tall
integrated
microwave
top unit
Application examples
Unit preparation
1 2
109
Hob wall cabinet
- Modification for microwave housing
Hob wall/Half-height wall/Bridging cabinet
Section 4 - Kitchen installation - Wall cabinets
600mm Integrated
microwave top unit
Mark out the cabinet end fixing
positions and secure the bracket
using the screws.
Mark out the frontal and fit the bracket
using the screws to secure.
137mm
Door top edge
32mm
141mm
32mm
32mm
37mm
500/600/800mm
Half height cabinet 1000mm Bridging cabinet 1200mm Half height cabinet
Fit the door to the cabinet
using the hinges.
Clip on the flap-stay to the
brackets, clicking into
position.
CLICK
CLICK
Adjustment setting number.
Adjustment
Adjust the tension in the flap-stay +/-
to frontal weight (if applicable with
handle fitted).
NOTE: A power driver with a PZ-2 bit
can be used.
NOTES: When fitting two half height wall cabinets on top of each other, any gaps between cabinets can be
filled with a suitable caulk or silicone filler. Two half height wall cabinets on top of each other will require
a magnetic catch (push to open) fitted to the top cabinet.
Gaps
Assembly
21
3
4
  • Page 1 1
  • Page 2 2

Howdens Joinery HCB3483 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI