51mm
MIN.
CLEARANCE
6"
152mm
3 1/4"
Ø1/8"
3.2mm
(SINK)
PIN
3-1/4"
83mm
83mm
3 3/4"
95mm
13-3/8
340mm
7"
178mm
1/2" O.D.
SUPPLY (COLD)
13"
330mm
LOCKNUT
2-3/8"
60mm
2"
WALL
ROLL
6
(SEE SHEET 2 FOR 7610S WALL MOUNTED CONFIGURATION)
7610S DECK MOUNTED CONFIGURATION
4
CAP
OFF
POSITION
ON
POSITION
38mm
1 1/2" MAX.
SET
SCREW
SEAL BASE WITH
SILICONE CAULK
APPROVED:
DRAWN:
PART NUMBER
SCALE: SHEET OF
REVISION
DRAWING TYPE: SIZE: A
BY:ECN NO.
DATE:
DATE:
ECN:
REVISED PER
CHK'D.:
Haws Corporation - All Rights Reserved. HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
CR
MODEL(S)
1455 KLEPPE LANE
SPARKS, NEVADA 89431
(775) 359-4712 FAX (775) 359-7424
E-MAIL: [email protected]
WEBSITE: WWW.HAWSCO.COM
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
JP
05/21/18
1
0580000836.D
7610S
PULLDOWN EYE/FACE WASH (SHORT)
1:1
13
MJ
08/08/18
5313
FV
INSTALLATION
5313
2018
JP
(SEE SHEET 3 FOR 7610S DECK MOUNTED DETAIL)
33"- 53"
838 mm-1346 mm
FLOW PATTERN
FLOOR
OFF
POSITION
3
NOTES:
1. WHEN INSTALLING THIS UNIT, LOCAL , STATE, OR FEDERAL CODES SHOULD BE ADHERED TO FOR
INSTALLATION DIMENSIONS (LOCATIONS), WASTE AND SUPPLY REQUIREMENTS OTHER THAN SHOWN.
2. TO COMPLY WITH ANSI Z358.1-2014 FOR EMERGENCY EYEWASH OR EYE/FACE WASH:
EYEWASH OR EYE/FACE WASH SHALL BE POSITIONED SUCH THAT FLUSHING FLUID PATTERN IS NOT
LESS THAN 33" (838mm), NO GREATER THAN 53" (1346mm) FROM SURFACE ON WHICH USER STANDS,
AND 6.0" (153mm) MINIMUM FROM WALL OR NEAREST OBSTRUCTION.
3 HEIGHT IS DETERMINED BY WATER FLOW PATTERN HEIGHT SHOWN, WHICH IN TURN, IS DEPENDENT
ON IN-LINE SUPPLY PRESSURE.
4 DRILL ONE Ø7/8" [22mm] HOLE AND TWO Ø5/32" HOLES WHERE UNIT IS TO BE INSTALLED. REFER TO
MOUNTING HOLE DETAIL ON SHEET 2 OF 3 OR 3 OF 3.
5 ASSEMBLE EYE/FACE WASH TO ARM; ORIENT TAB ON ASSEMBLY AWAY FROM USER.
6. DIMENSIONS MAY VARY BY ±1/2" (13 mm).
3-3/4"
95mm
7"
178mm
1/2" O.D.
SUPPLY
(COLD)
WALL
4
6
7610S WALL MOUNTED CONFIGURATION
1-1/2" MAX.
38mm
13"
330mm
OFF
POSITION
ON
POSITION
STEP 1 (SEE SHEET 1 FOR 7610S DECK MOUNTED CONFIGURATION)
EYEWASH
CONTROL
VALVE SEAL BASE WITH
SILICONE CAULK
BASE
SET
SCREW
SPOOL
UNIT IS SHIPPED IN DECK MOUNT CONFIG-
URATION. TO CONVERT TO WALL MOUNT
CONFIGURATION, POSITION ARM IN "DECK
MOUNT OFF POSITION" AS ABOVE.
1"
25.4mm
CAP
13-3/8"
340mm
1/2"
12.7mm
MOUNTING HOLE DETAIL
SET
SCREW
3-1/4"
83mm
OFF POSITION
DECK MOUNT
FLOOR
LINE
FLOOR
LINE
CONVERT TO WALL
MOUNT CONFIGURATION
APPROVED:
DRAWN:
PART NUMBER
SCALE: SHEET OF
REVISION
DRAWING TYPE: SIZE: A
BY:ECN NO.
DATE:
DATE:
ECN:
REVISED PER
CHK'D.:
Haws Corporation - All Rights Reserved. HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
CR
MODEL(S)
1455 KLEPPE LANE
SPARKS, NEVADA 89431
(775) 359-4712 FAX (775) 359-7424
E-MAIL: [email protected]
WEBSITE: WWW.HAWSCO.COM
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
JP
05/21/18
1
0580000836.D
7610S
PULLDOWN EYE/FACE WASH (SHORT)
1:1
23
MJ
08/08/18
5313
FV
INSTALLATION
5313
2018
JP
Ø 7/8"
22mm
2X 0.53"
13.5mm 2X Ø 5/32"
3.18mm
2X 0.53"
13.5mm
(SEE SHEET 3 FOR 7610S DECK MOUNTED DETAILS)
STEP 2
WALL MOUNT
DECK MOUNT
OFF POSITION
OFF POSITION
BASE
SET
SCREW
NOTE DEPTH OF SET SCREW PRIOR TO LOOSENING.
LOOSEN SET SCREW AND ROTATE EYEWASH ARM
90° CLOCKWISE (AS SHOWN) WHILE MAKING SURE
TO NOT ROTATE THE SPOOL. RE-TIGHTEN SET
SCREW IN NEW POSITION. ENSURE SET SCREW IS
PROPERLY SEATED IN INDENT. ENSURE SET SCREW
IS TIGHT AND AT IT'S ORIGINAL DEPTH. ENSURE
CORRECT ARM ORIENTATION BEFORE MOUNTING
TO WALL. REFERENCE DRAWINGS AT RIGHT.
33"- 53"
838 mm-1346 mm
FLOW PATTERN
3
LOCK NUT
Ø1/8" ROLL PIN
3.2mm 4
4
7610S DECK MOUNTED CONFIGURATION
(SEE SHEET 1 FOR 7610S DECK MOUNTED CONFIGURATION)
MOUNTING HOLE DETAIL
APPROVED:
DRAWN:
PART NUMBER
SCALE: SHEET OF
REVISION
DRAWING TYPE: SIZE: A
BY:ECN NO.
DATE:
DATE:
ECN:
REVISED PER
CHK'D.:
Haws Corporation - All Rights Reserved. HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
CR
MODEL(S)
1455 KLEPPE LANE
SPARKS, NEVADA 89431
(775) 359-4712 FAX (775) 359-7424
E-MAIL: [email protected]
WEBSITE: WWW.HAWSCO.COM
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
JP
05/21/18
1
0580000836.D
7610S
PULLDOWN EYE/FACE WASH (SHORT)
1:1
33
MJ
08/08/18
5313
FV
INSTALLATION
5313
2018
JP
Ø 7/8"
22mm
2X 0.53"
13.5mm 2X Ø 5/32"
3.18mm
2X 0.53"
13.5mm
OFF
SINK
(REFERENCE)
5" (127mm)
MIN. CLEARANCE
RADIUS FOR
FACEWASH STREAMS
6" (152mm) MIN.
CLEARANCE
ON
(SEE SHEET 2 FOR 7610S WALL MOUNTED CONFIGURATION)
DECK MOUNT DETAIL
-
1
-
2
-
3
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Haws 7610s User guide
-
-
-
-
-
-
-
-
-
Haws 3612F User manual
Other documents
-
Motorola Rapture User manual
-
Oasis 504433 Installation guide
-
Honeywell SMART 位置传感器 100º 和 180º 角位移传感器安装说明 Installation guide
-
ROCCAT Ryos MK (ROC-12-611-BK) User manual
-
Catler CL 2010 CHILLER User manual
-
-
Generac 2500PSI Owner's manual
-
ROCCAT Lua (ROC-11-310) User manual
-
-