Suntec RC 2000 Series Operating instructions

Type
Operating instructions
Su
nt
ec
®
RC 2000
Infrared Heater
Questions Call 1-888-499-8120
For technical questions go to www.suntec.us
Remote Control
Press once to Turn Fan on only.
Press Twice to Turn Heat On
Press until heater turns off
FAN/Heater/ Pw
Remote Controller
The RC 2000 series is Suntec’s top of the line infrared
Heater and comes with a remote control. The Infrared tech-
nology we use in the MRC 2000 produces warm air that
blends with the air in your rooms. This recirculation produc-
es a warm environment at a very economical cost.
Operation very simple,just position the Heater about 6
inches from a wall and plug it in. On the front panel of
the heater you will notice a control panel. It controls the
operation of the heater.
Timer + _
Set the thermostat by pressing the
these buttons.
Press timer button to set, in 30
minute increments, a shut off time.
You can cycle through to get back
to 0. This feature must be reset to 0
when used for normal operation. If
the time as been set it will continue
to turn off at the indicated hour un-
less the heater is turned off with
the power button.
Press once to turn Fan on only.
Press Twice to turn the system off.
FAN/Power
Press to turn on the heater
See the Timer on the
remote contol panel
for details
Set the thermostat
by pressing the these
buttons.
Timer
+ _
Heater
The rst time you turn on the heater it may produce heat. If this
happens the ambient temperature in the room my be higher then
the default temperature setting in the heater thermostat. PRESS the
Heater button then the + button until the temperature reading on
the front panel is above the ambient room temperature, the heater
will come on.
The thermostat is designed to maintain the room temperature
within 3 degrees. This means the heater will turn off when the tem-
perature you set the thermostat for is reached and will turn on when
the temperature drops 3 degrees.
The temperature displayed on the heater thermostat will vary from
the temperature displayed on the main house furnace. This is due to
the difference in the temperature of the air at the main house and
Suntec heater thermostats. The air around the Suntec thermostat
will be of a higher temperature in most cases than the air around
the main house thermostat. This is because the main system is off
and the Suntec is warming and re-circulating the air. There could be
a difference of as much as 10 degrees.This is normal and re ects the
accuracy and the effi ciency of Suntec.
Operating instructions
Please read prior to installing the Heater
Keep the heater 3 feet away from combustible materials such
as furniture, pillows, bedding, papers, clothes and curtains.
The front exhaust vent of the heater is hot when in operation
do not touch it.
Before unplugging the heater turn the heater power switch off
(located on front of unit)
If heater cord is damaged or the heater malfunctions unplug
the cord from the AC outlet. Contact a service facility.
The heater is not intended to be used outdoors or in bath-
rooms or in locations with standing water.
The front and back vents of the heater must not be obstructed
by any surface or wall. Keep the area in front of the heater
clear of any objects. Position the heater so its back is at least
6 inches from any wall or surface. The intake vent on the back
of the heater must not be obstructed.
Any modifi cation or non-authorized repair voids any and all
warranties.
The heater power cord is equipped with a grounded 3 pin AC
plug. Use proper UL approved adapters when connecting to
a 2 plug output receptacle.
The heater requires 120 Volts AC at 12.8 amps (1500 watts)
do not connect the heater to a circuit that is rated less then 15
amps at 120 Volts AC. If connected to a power strip the total
load on the power strip must not exceed its rated amps (cur-
rent). Any extension cords used to connect the heater to AC
must be rated at more than 1500 watts(12.8 amps).
Warning
Improper use could result in electric shock, fi re and injury
to people.
Suntec warrants this product free from defects in material
and workmanship for 2 years from provable date of pur-
chase in continental United States and Canada.
Within this warranty period, Suntec will repair or replace,
at its option, defective parts at no charge. Please call the
toll free number listed below if your heater is not operating
properly or if you have questions.
Within this warranty period, Suntec will repair or replace,
at its option, defective parts at no charge.Please call the toll
free number listed below if your heater is not working prop-
erly.
This warranty does not cover improper installation, mis-
use, abuse or neglect on the part of the owner. Warranty
is also invalid in any case that the product is taken apart or
serviced by an unauthorized service station. The Warranty
remains in effect if Suntec tech support instructs you on in-
stalling a part.
This warranty gives you, specifi c legal rights, which may
vary from state to state and country. It does not cover areas
outside of the United States or Canada.
Warranty
1-888-499-8120
Made in China
Warranty
Questions call 1-888-499-8120
Operating Instructions
Model 2000
Series RC2000
REV C
  • Page 1 1
  • Page 2 2

Suntec RC 2000 Series Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI