Dacor AEHK2CP Planning Guide [337 KB]

Category
Cooker hoods
Type
Planning Guide [337 KB]
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
EH, EHR, MH
Renaissance
®
30”, 36”, 42”, 48” and 54” Wide
Wall Mount Range Hoods
Document # PG07-004
Revised 07/07/14 Page 1/3
Overall Dimensions
Model A B C
EH/EHR3012 29 7/8” (75.9 cm)
26 7/8”
(68.3 cm)
12 3/8”
(31.4 cm)
EH/EHR3612 35 7/8” (91.1 cm)
EH/EHR4212 41 7/8” (106.4 cm)
EH/EHR4812 47 7/8” (121.6 cm)
MH3012 29 7/8” (75.9 cm)
25 1/2”
(64.8 cm)
MH3612 35 7/8” (91.1 cm)
MH4812 47 7/8” (121.6 cm)
EH/EHR3018 29 7/8” (75.9 cm)
26 7/8”
(68.3 cm)
18”
(45.7 cm)
EH/EHR3618 35 7/8” (91.1 cm)
EH/EHR4218 41 7/8” (106.4 cm)
EH/EHR4818 47 7/8” (121.6 cm)
EH/EHR5418 53 7/8 (136.8 cm)
MH3018 29 7/8” (75.9 cm)
25” 1/2
(64.8 cm)
MH3618 35 7/8” (91.1 cm)
MH4818 47 7/8” (121.6 cm)
11 7/8”
(30.2 cm)
A
B
C
OVERALL DIMENSIONS
NOTE: The exhaust duct(s) and electrical wiring can be
connected from either the top or the back of the hood.
DIMENSIONS OF OPTIONAL AHT10 TRANSITION
32”
(81.3 cm)
13 ¾
(34.9 cm)
¾”
(1.9 cm)
9”
(22.9 cm)
2” (5.1 cm)
Minimum Cabinet Width
Models D
EH3012, EH3018, MH3012, MH3018 30” (76.2 cm)
EH3612, EH3618, MH3612, MH3618 36” (91.5 cm)
EH4212, EH4218 42” (106.7 cm)
EH4812, EH4818, MH4812, MH4818 48” (121.9 cm)
EH5418 54” (137.2 cm)
E
E
25” min.*
(63.5 cm)
Electrical
access
* From cooking
surface
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
WARNING
Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
This appliance must be installed in accordance with the
accompanying installation instructions.
* 30 inches for EHR series. The minimum specified distance may be
higher for the particular range or cooktop in use. Check the manufacturers
specifications for the cooktop or range.
D
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
EH, EHR, MH
Renaissance
30”, 36”, 42”, 48” and 54” Wide
Wall Mount Range Hoods
Document # PG07-004
Revised 07/07/14 Page 2/3
Weight Specifications
Models Weight
EH3012, MH3012 48 lbs. (22 kg)
EH3018, MH3018,
EH3612, MH3612
53 lbs. (24 kg)
EH3618, MH3618 57 lbs. (26 kg)
EH4212 55 lbs. (25 kg)
EH4218 60 lbs. (27 kg)
EH4812, MH4812 70 lbs. (32 kg)
EH4818, MH4818 77 lbs. (35 kg)
EH5418 84 lbs. (38 kg)
All Models
Fan speeds 4
Filters Mesh type, dishwasher safe
Exhaust(s) 8-inch
Total connect load
120 Vac, 60 Hz, 9 Amp. Max.
(10.0 Amp. Max. surge)
Lights 120 Vac, 75 W halogen
Circuit requirement 120 Vac, 15 Amp. dedicated, grounded circuit
Model Specific
EH48, EHR48,
MH48, EH54
EH42, EHR42
EH30, EHR30,
MH30, EH36,
EHR36, MH36
Lights 3 2 2
Filters 4 3 2
Exhaust
outputs
2 1 1
Fan* rating 1200 CFM 600 CFM 600 CFM
* Does not apply to EHR Series
GENERAL SPECIFICATIONS
Weight Specifications
Models Weight
EHR3012 39 lbs. (18 kg)
EHR3018, EHR3612 44 lbs. (20 kg)
EHR3618 48 lbs. (22 kg)
EHR4212 46 lbs. (21 kg)
EHR4218 51 lbs. (23 kg)
EHR4812 52 lbs. (24 kg)
EHR4818 59 lbs. (27 kg)
EHR5418 66.4 lbs. (30 kg)
Duct Size
Maximum Straight
Duct Run
8” round 60 feet
10” round 50 feet
3¼” X 10” rectangular 50 feet
IMPORTANT: When planning the installation, you must calculate the actual
length the duct work cannot exceed. To calculate actual maximum duct
length, use the above specifications in combination with the Duct Planning
Guide or see the hood installation instructions.
IMPORTANT: Local building codes may require the use of makeup air
systems with ventilation systems that move air greater than the specified
movement rate (CFM). The specified rate varies based on locale. Consult a
qualified HVAC specialist when designing the system for the requirements
in your area and to assure optimal performance.
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
EH, EHR, MH
Renaissance
30”, 36”, 42”, 48” and 54” Wide
Wall Mount Range Hoods
Document # PG07-004
Revised 07/07/14 Page 3/3
NOTE: The exhaust duct(s) and electrical wiring can be connected from either the top or the back of the hood.
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated.
Models EH48, EHR48, MH48, EH54, EHR54
All other models
*
**
BACK DIMENSIONS
3” (7.6 cm)
¾” (1.9 cm)
Electrical access holes
7/8” Dia. (5.1 cm)
C
L
Bottom of
hood
Dual exhaust models*
Standard 8” duct connection
Single exhaust models**
Standard 8” duct connection
9 7/8”
(25.1 cm)
19 ¾”
(50.2 cm)
4” (10.2 cm)
E***
Front of
hood
Dual exhaust models*
Standard 8” duct connection
C
L
Electrical access holes
7/8” Dia. (5.1 cm)
1 ½” (3.8 cm)
6 1/8”
(15.6 cm)
C
L
C
L
Single exhaust models**
Standard 8” duct connection
3” (7.6 cm)
4” (10.2 cm)
9 7/8”
(25.1 cm)
19 ¾”
(50.2 cm)
TOP DIMENSIONS
***Rear Exhaust Placement
Nominal Hood Height E
12” 4 1/2” (11.4 cm)
18” 6 1/8” (15.6 cm)
  • Page 1 1
  • Page 2 2
  • Page 3 3

Dacor AEHK2CP Planning Guide [337 KB]

Category
Cooker hoods
Type
Planning Guide [337 KB]

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI