V-ZUG 51027 Installation guide

51027
V-ZUG
Brand
V-ZUG
Model
51027
Type
Installation guide

This manual is also suitable for

Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Installation instructions
Prestige KPRPieco, KPRieco, KPRi Refrigerator
Built-in EURO 60
J51027051-R07
10178925
20.10.15
7
These installation instructions apply to model: 51027, 51044, 51045, 51052
➤ Information on the necessary mains voltage, type of current and fuse protection can be taken from the identification plate.
➤ Push the appliance into the niche. Secure to the cabinet with 1 screw (included in the scope of delivery) through each hinge. Then
secure the appliance to the cabinet at the top with 2 chipboard screws each (included in the scope of delivery) through the fixing bar.
➤ Operate the appliance in accordance with the operating instructions supplied.
➤ Ensure that the appliance is switched off if it is not intended that the appliance be used immediately after installation.
Validity
This appliance is considered to be suitable for use in countries having a warm damp equable climate (WDaE). It may also be
used in other countries. If used in warm damp equable climated countries, the appliance is to be supplied through a residual
current device (RCD) having a rated residual operating current not exceeding 30 mA.
General notes
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
If installing into combustible material, the guidelines and safety standards for low voltage installations and fire protection must
be strictly observed.
Electrical connections
Electrical connections must be carried out by suitably qualified personnel in accordance with the guidelines and safety
standards for low voltage installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. A
mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket
devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are
permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-
free operation.
After installation, live parts and cables with basic insulation must not be accessible.
Check old installations.
Installation
The door opening can be changed from right to left up until the point when the appliance is installed in the niche.
Installation instructions
Prestige KPRPieco, KPRieco, KPRi Refrigerator
Built-in EURO 60
J51027051-R07
10178925
20.10.15
8
Built-in, integratable door
* Allow a gap – at the top and bottom – less than the width of the appliance to ensure proper ventilation
(sheets 5–13 in the technical guide on kitchen planning and design from the Swiss Kitchen Association (KVS)).
Shadow gaps alone – even if extended over several elements – are not sufficient.
a Niche overlap
bGap
w
A For door panel thickness greater than 19 mm, use hinge bolts supplied.
– This restricts the opening radius to a maximum of 90°.
=
=
100
120
min. 200 cm²min. 200 cm²
min. 4
a
min. 4
b
635 = 5/6 1143 = 9/6
a
16–20
min. 50
+2
0
+2
0
2050 Flush-mounted power socket, «type 13»
Niche 1778 = 14/6
600
Width of element
Appliance 1776
545
Appliance
Ventilation cross-section *
Door panels
Niche 1778 = 14/6
Positioned BELOW
also possible
Positioned ABOVE
standard
16–20
1143 + a – b635 + a – b 2b
~602
100°
max. 594
w
Filler strip H7.1756
(request when ordering
appliance)
548
Appliance
Door panels
560–568
Niche
550
Niche
Detail A
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

V-ZUG 51027 Installation guide

51027
V-ZUG
Brand
V-ZUG
Model
51027
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents