2. Grace Company
  3. Presser Foot Collar

Grace Company Presser Foot Collar Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Grace Company Presser Foot Collar Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation Instructions:
SHCS M3 x 8 mm
HDW-03-10966
(Preinstalled)
A A
B B
2
2
1
1
DO NOT SCALE DRAWING
M3 Thumb Screw
SHEET 1 OF 1
UNLESS OTHERWISE SPECIFIED:
SCALE: 4:1
WEIGHT:
REV
DWG. NO.
A
SIZE
TITLE:
NAME
DATE
COMMENTS:
Q.A.
MFG APPR.
ENG APPR.
CHECKED
DRAWN
FINISH
MATERIAL
INTERPRET GEOMETRIC
TOLERANCING PER:
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
ANGULAR: MACH
BEND
TWO PLACE DECIMAL
THREE PLACE DECIMAL
APPLICATION
USED ON
NEXT ASSY
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
<INSERT COMPANY NAME HERE>. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
<INSERT COMPANY NAME HERE> IS
PROHIBITED.
Parts List:
The Presser Foot Collar can be used to quickly swap between a variety of foot accessories foot your
machine.
Use:
Use a 3 mm Allen wrench to remove the
screw attaching the hopping foot to the
hopping foot collar on your machine.
Hopping Foot
Collar
Hopping Foot
Screw
Remove the needle bar thumb screw and
carefully pull out the needle.
2
Needle Bar
Thumb Screw
Presser Foot Collar SM21
SMP-09-14524
1
Standard Hopping Foot
SMP-04-10057
Q’nique21 Machine
Presser Foot Collar
Instructions
Place the new standard hopping foot onto
the hopping foot collar bar. Attach with a hopping
foot screw loosely enough that the hopping foot
can slide up and down.
Slide the hopping foot height tool
under the hopping foot, tting the groove
around the needle. Tighten the hopping
foot screw with a 3 mm Allen wrench.
Installation Instructions Continued:
With a 3 mm Allen wrench, loosen the
hopping foot collar screw just enough so that
the collar can be pulled o the machine.
3
Hopping Foot
Collar Screw
Slide the new hopping foot collar
that came with this kit onto the press bar.
Make sure the bottom of the collar is even
with the bottom of the press bar. Hold in
place with the hopping foot collar screw.
4
New Hopping
Foot Collar
5
New Standard
Hopping Foot
Reinstall your machine’s needle and
needle thumb screw (see your machine
manuals for details).
6
Slowly lower your needle to the lowest
position.
7
Press Bar
8
Hopping Foot
Height Tool
Copyright May 19, 2021 Version 1.0 Grace Company
/