DB Drive EUPHORIA T465 User manual

Brand: DB Drive

Model: EUPHORIA T465

Type: User manual

EUPHORIA

Two

EUPHORIA

AMPLIFIER MODELS

T265 : T465 : T490 : T4125 : M350 : M500 : M1000 : M2000

USER MANUAL

Installation Instructions / Owners Manual

Due to continous improvement of the product the

specifications are subject to change without notice.

INTRODUCTION SAFETY PRECAUTIONS

KEEP YOUR SALES RECEIPT

RECOMMENDATION

Low Impedance Stability

For added low frequency performance the Multi Channel amplifiers are equipped with a

bass boost @ 45Hz

The “EUPHORIA ” amplifiers include built-in variable crossovers. The crossover features

a variable frequency selection for precise low pass filtering for all mono amplifiers. The

Multi-channel feature independent 12dB per octave High Pass and Low Pass X-Over

Network.

T265 - 2 Ohm Stereo (2 Channel)

F465 - 2 Ohm Stereo (4 Channel)

F490 - 2 Ohm Stereo (4 Channel)

F4125 - 2 Ohm Stereo (4 Channel)

M350 - 2 Ohm Mono

M500 - 1 Ohm Mono

M1000 - 1 Ohm Mono

M2000 - 1 Ohm Mono

selectable 6dB-12dB

The Mono amplifiers feature a variable 0 - 18db boost set @ 45Hz

Tri - Plex Status Indicator

A Tri-Plex LED status indicator will indicate the operational status of the amplifier.

A blue power LED indicates the power is on and operating normal. To aid in setting up

the amplifier a CLIP LED , will be off during normal operation. When the amplifier is over

driven into a soft clip it will light up orange , this is the normal safe limit of operation of

signal. When the amplifiers signal goes into a dangerous hard clip the Clip LED will turn

red. A red protection LED indicates that the internal protection circuit has been activated.

The protect LED will remain off at all other times

FEATURES AND BENEFITS Multi-Link

The Euphoria M500, M1000 and M2000 have an internal linking circuit that allows you

to link two like model amplifiers so that you can double your output power to a single load.

When linking two like amplifiers they are split up into master and slave units. The master

amplifier becomes the main control for all input signals and gain controls.

Ground Remote +12V Fuse Speaker Output

Power Output

+ +

MOUNTING LOCATION POWER CONNECTIONS

Bass Boost

Remote 0dB 18dB 10Hz 40Hz 40Hz

M350 CLASS A/B MONOBLOCK

300Hz Min Max

R R

Subsonic Lowpass Gain

OUTPUT INPUTX-Over Controls

LP/BP 12dBStereo

Mode

HP 12dB

High Pass

Channel 1 & 2 Over Controls

Min MaxMin Max

HPFull

5KHz

20Hz

Gain

F465

Ch 3 Ch 3 Ch 1

Ch 2

INPUT

X-OVER

INPUT

High

Pass

Channel 3 & 4 X-Over Controls

Low

Pas s

Bass

Boost Gain

OUTPUT

Ch 4Ch 4

20Hz 1KHz 50Hz 5KHz 0dB 12dB

LP/BP Mono 24dB

4 CHANNEL AMPLIFIER

Ground Remote +12V Fuse Speaker Output

Power Output

+ +

M350 - 2 ohm stable

M500 - 1 ohm stable

M1000 - 1 ohm stable

M2000 - 1 ohm stable

M350 - 2 ohm stable

M500 - 1 ohm stable

M1000 - 1 ohm stable

M2000 - 1 ohm stable

Ground Remote +12V Fuse Speaker Output

Power Output

+ +

SIGNAL CONNECTIONS SPEAKER CONNECTIONS

Multi - Channel

SPEAKER CONNECTIONS Multi-Link

REMOTE BASS CONTROL MODULE

Ch 1 Ch 2 Ch 3 Ch 4

Bridged Bridged

+-- -

Fuse

Ground Remote +12V Speaker Output

PowerOutput

Ch 1 Ch 2 Ch 3 Ch 4

Bridged Bridged

+-- -

Fuse

Ground Remote +12V Speaker Output

PowerOutput

REMOTEBRIDGED

SLAVE

Min Max 15Hz 40Hz 50Hz 150Hz 0dB 18dB

180

0MASTER

DATALINK

GAIN SUBSONIC LOWPASS BASSBOOST

OUTPUT INPUT

REMOTEBRIDGED

SLAVE

Min Max 15Hz 40Hz 50Hz 150Hz 0dB 18dB

180

0MASTER

DATALINK

GAIN SUBSONIC LOWPASS BASSBOOST

OUTPUT INPUT

REMOTEBRIDGED

SLAVE

Min Max 15Hz 40Hz 50Hz 150Hz 0dB 18dB

180

0MASTER

DATALINK

GAIN SUBSONIC LOWPASS BASSBOOST

OUTPUT INPUT

M500 M1000 M2000

POWER INPUT

OUTPUTSPEAKER

12V

+ +

- -

REM GND

POWER INPUT

OUTPUTSPEAKER

12V

+ +

- -

REM GND

2 Ohm Minimum

Master

Slave

Master

Slave

The Euphoria M500, M1000 and M2000 have an internal linking circuit that allows

you to link two like model amplifiers so that you can double your output power to a

single load. When linking two like amplifiers they are split up into master and slave

units. The master amplifier becomes the main control for all input signals and gain

controls.

network that allows you to select the crossover mode (Highpass—Full Range) and desired

crossover point for channels 1 and 2. Channels 3 and 4 allow you to select between a

Highpass 12db slope, a 12db Stereo Lowpass / Bandpass slope and a mono 24db Lowpass /

Bandpass slope. For example if you wish to drive a pair of subwoofers on channels 3 and 4

out the high frequencies with a 24db slope. You will then need to adjust the Lowpass

control to the desired frequency setting (make sure to have the Highpass control set to

switch to LP/BP stereo. Once the LP/BP stereo switch setting is selected you will use both

any unwanted low frequencies with a 12db slope.

The M350 , M500, M1000 and M2000 are equipped with a variable 24db slope

feature a variable Bass Boost EQ is set at 45Hz. In some subwoofer enclosure installations it

may necessary to use the Phase Shift feature. The Phase Shift button sets the Subwoofer

subwoofer enclosure. M500, M1000 and M2000 are equipped with Multi-Linking technology.

When using a single Linkable amp set the Master / Slave switch to the Master position.

the slave setting the front panel controls become inoperative. All adjustments for both

( T265, F465, F490, F4125)

Built-in Crossover

( M350 , M500, M100 M2000 )

T265 , F465, F490 and F4125

LP/BP 12dBStereo

Mode

HP 12dB

High Pass

Channel 1 & 2 Over Controls

Min MaxMin Max

HPFull

5KHz

20Hz

Gain

F465

Ch 3 Ch 3 Ch 1

Ch 2

INPUT

X-OVER

INPUT

High

Pass

Channel 3 & 4 X-Over Controls

Low

Pas s

Bass

Boost Gain

OUTPUT

Ch 4Ch 4

20Hz 1KHz 50Hz 5KHz 0dB 12dB

LP/BP Mono 24dB

4 CHANNEL AMPLIFIER

Euphoria

ADJUSTMENTS AND SETTINGS ADJUSTMENTS AND SETTINGS

FINE TUNE THE SYSTEM

Peak @ 14.4V :

2ohm

Frequency Resp.

S/N Ra o (A-weight)

THD with 80k ﬁlter

Low Input Level

Crossover Freq.

Bass EQ

Bass Remote Capability

Input Voltage

M350

1 x 350W

N/A

20Hz - 350Hz

<0.4%

50Hz - 350Hz

0dB - 18dB @ 45Hz

Yes

11.2V - 14.4V

M500

1 x 250W

1 x 500W

20Hz - 150Hz

<0.4%

50Hz - 150Hz

0dB - 18dB @ 45Hz

Yes

11.2V - 14.4V

M1000

1 x 500W

1 x 1000W

20Hz - 150Hz

<0.4%

50Hz - 150Hz

0dB - 18dB @ 45Hz

Yes

11.2V - 14.4V

1ohm

Dimensions Height WidthLength

T2652.16in/55mm 8.66in/220mm7.87in/200mm

F4652.16in/55mm 8.66in/220mm12.51in/318mm

F4902.16in/55mm 8.66in/220mm14.84in/368mm

F41252.16in/55mmm 8.66in/220mm16.49in/368mm

M3502.16in/55mm 8.66in/220mm12.51in/318mm

M5002.16in/55mm 8.66in/220mm10.53in/255mm

Peak @ 14.4V :

4 ohms

4 ohms bridged

Frequency Resp.

S/N Ra o (A-weight)

THD with 80k ﬁlter

Low Input Level

High Pass Filter

Bass EQ

Bass Remote Capability

Input Voltage

Low Pass Filter

T265

2 x 65W

1 x 250W

18Hz - 22KHz

>10 dB

<0.4%

250mV - 6 V

20Hz - 5KHz

50Hz - 5KHz

6dB - 12dB @ 45Hz

11.2V - 14.4V

2 x 85W

F465

4 x 85W

2 x 250 W

<0.5%

20Hz - 5KHz

50Hz - 5KHz

6dB - 12dB @ 45Hz

11.2V - 14.4V

4 x 65W

F490

4 x 125W

2 x 350W

<0.5%

20Hz - 5KHz

6dB - 12dB @ 45Hz

11.2V - 14.4V

4 x 90W

2 ohms

0 >10 dB0 >10 dB0

250mV - 6 V

50Hz - 5KHz

18Hz - 22KHz 18Hz - 22KHz

F4125

4 x 195W

2 x 400W

<0.5%

20Hz - 5KHz

6dB - 12dB @ 45Hz

11.2V - 14.4V

4 x 125W

>10 dB0

250mV - 6 V

50Hz - 5KHz

18Hz - 22KHz

M2000

1 x 1000W

1 x 2000W

20Hz - 150Hz

<0.4%

50Hz - 150Hz

0dB - 18dB @ 45Hz

Yes

11.2V - 14.4V

>10 dB0 >10 dB0 >10 dB0 >10 dB0

250mV - 6 V

Crossover Slope

12dB 24dB 24dB 24dB

Subsonic Filter Range

10Hz - 40Hz 15Hz - 40Hz 15Hz - 40Hz 15Hz - 40Hz

M10002.16in/55mm 8.66in/220mm11.25in/286mm

M20002.16in/55mm 8.66in/220mm17.36in/441mm

TROUBLE SHOOTING THE SYSTEM SPECIFICATIONS

DB Drive EUPHORIA T465 User manual

DB Drive EUPHORIA T465 User manual

DB Drive EUPHORIA T465 User manual

Related papers

Other documents