Moen HCBS-3PC-GCM Dimensions Guide

Brand: Moen

Model: HCBS-3PC-GCM

Type: Dimensions Guide

Moen HCBS-3PC-GCM is a three-piece bathroom safety set that includes a shower chair, bath mat, and tub grip. The shower chair is made of durable aluminum and plastic and can support up to 400 pounds. It has a mesh seat and back for breathability and comfort. The bath mat has a non-slip surface and can be easily installed on the floor of your bathtub or shower. The tub grip is also made of durable plastic and can be easily installed on the wall of your bathtub or shower. It provides a secure grip for getting in and out of the tub or shower.

25300 AL MOEN DRIVE  NORTH OLMSTED, OH 44070

CORPORATE HEADQUARTERS: (800) 321-8809  FAX: (800) 848-6636

INTERNATIONAL: (440) 962-2000  FAX: (440) 962-2726

CUSTOMER SERVICE (USA): 800-882-0116  FAX: (888) 379-2720

WWW.MOEN.COM

Copyright Creative Specialties International Literature #BA1445

Mesh material is Glass filled Polyester

with PVC coating.

Legs and Frame are 6063 Aluminum.

Seat back is Polypropylene.

Arms are Glass filled Polypropylene.

Feet are Thermoplastic rubber (TPR).

TO PREVENT SERIOUS OR FATAL INJURY:

Insure product is assembled, adjusted and used

properly. FOR USE ONLY BY PERSONS

WEIGHING LESS THAN 400 POUNDS. Failure

to follow correct assembly and/or adjustment

procedures can make the seat unstable. ALL

FOUR LEGS MUST BE LOCKED IN PLACE AT

THE SAME HEIGHT. DO NOT jump on, stand on

or tilt. Contact CSI immediately at 1-800-882-

0116 if any components are missing or damaged.

Do not modify or substitute any components.

FOR QUESTIONS OR ASSISTANCE WITH

ASSEMBLY CONTACT CSI AT 1-800-882-0116.

Consult healthcare professional for advice and

instructions specific to user’s needs before use.

 DN7100 – Premium Shower Chair

Stock Number:_________________ Premium Shower

Chair By Creative Specialties

Materials:

Stock Numbers:

Dimensions:

Premium Shower Chair

DN7100

Home Care Technical Specification

Bath Mat is made from polyvinyl

chloride with a pebbled top surface and

a waterproof adhesive backing.

 DN7050 – Bath Mat

Adhesive Backing

Photo Box Packaging

25300 AL MOEN DRIVE  NORTH OLMSTED, OH 44070 (800) 321 -8809 

FAX: (800) 848-6636  INTERNATIONAL: (440) 962-2000 

FAX: (440) 962-2726 CUST OMER SERVICE (USA): 800-882-0116

WWW.MOEN.COM

©Copyright Creative Specialties International Literature #BA1692

1. Prepare floor. Before beginning, make sure the tub or shower floor

is completely clean and dry.

2. Prepare mat. Peel away three inches of the paper backing along

the edge of the mat that will be located closest to the drain.

CAUTION: Do not touch the adhesive backing under the paper.

3. Position mat. Position the mat, paper side down, exactly where

you want it.

4. Secure mat. Gently press down the exposed section of the

adhesive against the floor surface. Then, reach under the mat and

slowly remove the remaining paper, stopping periodically to gently

press down the new exposed section of the mat. The mat will

adhere immediately. No drying is needed.

Stock Number:________________________Bath Mat

By Creative Specialties International

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Bath Mat

DN7050

Home Care Technical Specification

25300 AL MOEN DRIVE  NORTH OLMSTED, OH 44070

CORPORATE HEADQUARTERS: (800) 321-8809  FAX: (800) 848-6636

INTERNATIONAL: (440) 962-2000  FAX: (440) 962-2726

CUSTOMER SERVICE (USA): 800-882-0116  FAX: (888) 379-2720

WWW.MOEN.COM

Copyright Creative Specialties International Literature #BA1447

SecureLock™ Tub Grip is made from

Polypropylene. Tub pads are thermoplastic

rubber (TPR).

WARNING

TO PREVENT SERIOUS OR FATAL INJURY:

Insure product is assembled, adjusted and used

properly. FOR USE ONLY BY PERSONS

WEIGHING LESS THAN 350 POUNDS. Failure

to follow correct installation procedures can

cause the grip to become loose. Check after

installation to make sure grip is secure, and

check periodically to be sure grip remains secure.

For use only to assist in balance while entering

and exiting tub. Contact CSI immediately at 1-

800-882-0116 if any components are missing or

damaged. Do not modify or substitute any

components. FOR QUESTIONS OR

ASSISTANCE WITH ASSEMBLY CONTACT CSI

AT 1-800-882-0116. Consult healthcare

professional for advice and instructions specific to

user’s needs before use.

 DN7175 – SecureLock™ Tub Grip

Stock Number:_________________ SecureLock™ Tub

Grip By Creative Specialties

Materials:

Stock Numbers:

Dimensions:

SecureLock™ Tub Grip

DN7175

Home Care Technical Specification

Moen HCBS-3PC-GCM Dimensions Guide

Moen HCBS-3PC-GCM Dimensions Guide

Moen HCBS-3PC-GCM Dimensions Guide

Related papers

Other documents