25300 AL MOEN DRIVE NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 FAX: (800) 848-6636
INTERNATIONAL: (440) 962-2000 FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 FAX: (888) 379-2720
WWW.MOEN.COM
Copyright Creative Specialties International Literature #BA1446
Bench and Seat Back are High
Density Polyethylene (HDPE).
Legs are 6063 Aluminum.
Arms are Glass filled Polypropylene.
Feet are Thermoplastic Rubber (TPR).
Front Foot is Polypropylene.
WARNING
TO PREVENT SERIOUS OR FATAL INJURY:
Insure product is assembled, adjusted and used
properly. FOR USE ONLY BY PERSONS
WEIGHING LESS THAN 400 POUNDS. Failure
to follow correct assembly and/or adjustment
procedures can make the seat unstable. ALL
FOUR LEGS MUST BE LOCKED IN PLACE AT
THE SAME HEIGHT. DO NOT jump on, stand on
or tilt. Contact CSI immediately at 1-800-882-
0116 if any components are missing or damaged.
Do not modify or substitute any components.
FOR QUESTIONS OR ASSISTANCE WITH
ASSEMBLY CONTACT CSI AT 1-800-882-0116.
Consult healthcare professional for advice and
instructions specific to user’s needs before use.
DN7105 – Premium Transfer Bench
Stock Number:_________________ Premium Transfer
Bench By Creative Specialties
Materials:
Stock Numbers:
Dimensions:
Premium Transfer Bench
DN7105
Home Care Technical Specification
25300 AL MOEN DRIVE NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 FAX: (800) 848-6636
INTERNATIONAL: (440) 962-2000 FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 FAX: (888) 379-2720
WWW. MOEN.COM
Copyright Creative Specialties International Literature #BA1668
Peened Grab Bar rods are formed
from 18-guage type 304 stainless
steel tubing with a satin finish
LR2350DBN – Grab Bar with
Integrated Towel Bar
Brushed Nickel Finish
LR2350DOWB – Grab Bar with
Integrated Towel Bar
Old World Bronze Finish
LR2350DCH – Grab Bar with
Integrated Towel Bar
Chrome Finish
Stock Number:______________________Grab Bar with Towel Bar
By Creative Specialties
Materials:
Stock Numbers:
Dimensions:
Grab Bar with Towel Bar
LR2350D
Home Care Technical Specification
Compliance:
Grab Bar is made from Stainless Steel
Construction. SecureMount Anchor is
made from POM.
- Tested to 250 lbs. Weight Capacity
Bath Mat is made from polyvinyl
chloride with a pebbled top surface and
a waterproof adhesive backing.
DN7050 – Bath Mat
Adhesive Backing
Photo Box Packaging
25300 AL MOEN DRIVE NORTH OLMSTED, OH 44070 (800) 321 -8809
FAX: (800) 848-6636 INTERNATIONAL: (440) 962-2000
FAX: (440) 962-2726 CUSTOMER SERVICE (USA): 800-882-0116
WWW.MOEN.COM
©Copyright Creative Specialties International Literature #BA1692
1. Prepare floor. Before beginning, make sure the tub or shower floor
is completely clean and dry.
2. Prepare mat. Peel away three inches of the paper backing along
the edge of the mat that will be located closest to the drain.
CAUTION: Do not touch the adhesive backing under the paper.
3. Position mat. Position the mat, paper side down, exactly where
you want it.
4. Secure mat. Gently press down the exposed section of the
adhesive against the floor surface. Then, reach under the mat and
slowly remove the remaining paper, stopping periodically to gently
press down the new exposed section of the mat. The mat will
adhere immediately. No drying is needed.
Stock Number:________________________Bath Mat
By Creative Specialties International
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Bath Mat
DN7050
Home Care Technical Specification
-
1
-
2
-
3
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Moen HCBS-2PC-CM Dimensions Guide
-
-
-
-
-
-
-
-
Creative Specialties International YG5118BN Specification
-
