X10 SH10A Owner's manual

Brand: X10

Model: SH10A

Type: Owner's manual

X10 Wireless Technology, Inc. 90 Day Limited Warranty

X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10 products to be

free from defective material and workmanship for a period of 90 days from the original date

of purchase at retail. X10 agrees to repair or replace, at it’s sole discretion, a defective X10

product if returned to X10 within the warranty period and with proof of purchase.

If service is required under this warranty:

1. Visit www.x10.com/support/return_policy.htm, or e-mail [email protected] to obtain a

Return Merchandise Authorization (RMA) number.

2. Return the defective unit postage prepaid to X10 (see address on back).

3. Enclose a check for $4.00 to cover postage and handling.

4. Enclose a dated proof of purchase.

5. X10 is not responsible for shipping damage. Units to be returned should be packed

carefully.

Please visit www.x10.com/support for help.

SH10A-6/13

Check Out our Web site at:

www.x10.com

For more information on X10 products and

special promotional offers.

Print reduced by approx 85%.

Final size of above = approx. 7 3/4” x 4 3/4”

Folds into a sheet 3 7/8’ x 2 3/8”

(Like all other instruction sheets)

POWERHORN™ Remote Siren, Model SH10A

INSTALLATION INSTRUCTIONS

1. Set the Housecode dial on the SH10A to the same letter as your SC1200

security system, and to the same number as it’s security code.

2. If you want to control the SH10A from other types of X10 controllers, set

the Unit Code dial on the SH10A to any unused number between 1 & 16.

3. Plug the SH10A into any unused AC outlet (not one that is controlled by

a wall switch, in case the switch accidentally gets turned off).

OPERATING INSTRUCTIONS

WARNING:

The SH10A is extremely loud. To avoid permanent hearing damage,

do not stand too close to it when you trip the alarm.

1. To test the SH10A, trip your alarm system. The SH10A will sound for as

long as the alarm in the security system console sounds, and then shut off

a few seconds after you disarm the alarm.

2. To trip the SH10A from any X10 controller (if you hear a strange noise

at night, for example): Press Unit Code-ON, then Unit Code-OFF, then

Unit Code-ON, repeatedly. The SH10A will sound for as long as you keep

pressing ON and OFF and will stop a few seconds after you stop pressing

buttons. Or press Unit Code-ON and hold the button pressed for a few

seconds. Or press All Lights On, then All Units Off, repeatedly.

3. You can use the SH10A as an annunciator: Press Unit Code-ON, on any

X10 Controller and then press Dim or Bright. You will hear a ding or a

dong for each button press.

Trim Trim

Mini Timer MT13A

A Controller, Timer and Alarm Clock all in

one! Programs up to eight X10 Modules to

go on and off at speciﬁ c times, up to a total

of 64 timed events. Controls eight modules

instantly. Dims lights too.

Maxi Controller SC503

Lets you control up to 16 X10 Modules at

the touch of a button from anywhere in the

house. Dims lights too!

Mini Controller MC10A

Lets you control up to eight X10 Modules

at the touch of a button from anywhere in

the house. Dims lights too!

2-Way Home Control Interface CM15A

Set up from a PC to control up to 256

X10 Modules. ActiveHome Pro software

download & USB cable included.

Thermostat Set-Back TH2807

Automatically sets-back your central

heating/air conditioning. Mounts on the wall

under your existing thermostat and plugs

into an Appliance Module.

Wireless Remote Control System RC5000

Lets you control 16 X10 modules from inside

or outside your home. Can also dim and

brighten Lamp Modules and Wall Switch

Modules. Works with the HR12A PalmPad

Remote and X10 RF Wall Switches (SS13A,

SS15A).

Lamp Module PLM01

Can be Dimmed and Brightened from any

X10 Controller. Responds to “All lights on”.

Rated for 300 W. Incandescent only.

2-Way version LM14A.

SocketRocket LM15A

Screws in to an existing light ﬁ xture. Controls

up to 150W, incandescent only.

Appliance Module - AM486/AM466

Two pin polarized (AM486) or 3 pin

grounded (AM466). For controlling an air

conditioner, TV, stereo, etc. anywhere in the

home. Rated 15A for heaters, coffee pots

etc.; 1/3 H.P. for motors; 400W for TVs;

500W for lamps. 2-Way versions available

AM14A (2 pin), AM15A (3 pin).

Wall Switch Module WS467

For controlling important indoor and outdoor

security lights. Replaces your existing

wall switch and installs like a regular

dimmer. Dimmed/brightened from any X10

Controller. Rated 500W incandescent only.

3 - Way Wall Switch Module WS4777

For controlling a light which is controlled

by two switches. Same features as WS467.

Split Receptacle Module SR227

Replaces existing wall outlet. The top outlet

functions like an Appliance Module, the

bottom one is a regular outlet. Rated 15A.

Universal Module UM506

Isolated contact relay and beeper. Can be

set for momentary or continuous operation.

Not compatible with X10 security systems.

Trim Trim

X10 Wireless Technology, Inc.

400 Forge Way, Suite 409-412,

Rockaway, NJ 07866

RMA#

Tear off and keep the portion to the right (setup instructions are

on the other side of it) and keep for future use.

visit www.x10.com/support/return_policy.htm

or e-mail [email protected] to obtain a Return Merchandise

Authorization (RMA) number.

Write your RMA number above. Tear off and tape this label to

the outside of the package and mail it (postage prepaid).

X10 SH10A Owner's manual

X10 SH10A Owner's manual

Related papers

Other documents