Milwaukee Performance MPM1713-GRY-4X Installation guide

Installation Manual

Universal Battery Pack for Milwaukee Performance Heated Hoodie

 Triple Heat Setting, Low, Med, High

 Easy to Read Power Indicator Lights

 Plug in Wall Adapter

 12V 2600m Ion battery

Description:

One Single 12V/2600mAh Rechargeable Battery with Wall Charger and Triple Heat Setting

Suggested Use:

Jacket Battery Pack can ONLY be used on Milwaukee Leather Heated Hoodie – Batteries will not

work if used w/ other heated product (ex: Gloves or Jacket)

Plug in charged battery to connection cable on Hoodie. To turn on battery, press and hold

on/off for several seconds until light comes on (if light doesn’t turn on, the battery needs

charging). When on power starts at 100%, keep on high setting for five to ten minutes to warm

up the Hoodie. After the desired temperature is reached, turn the battery down to 50% to

increase Battery Life. Turn off the battery during extended breaks or indoors to extend your

usage time.

Warnings:

Do Not Wash or Put any Garment in the Dryer w/ the Battery Still inside

In extreme cold conditions always charge Battery to 100%, be aware that the battery will lose

power after a few hours of usage. It is strongly recommended to purchase an extra battery pack

for extreme cold conditions

Please note if the Battery Needs to be reset, plug into wall charger in the off position and

then turn on the power button. The will restart the battery