IMPORTANT:

• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.

• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!

• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!

PREPARING FOR INSTALLATION

Removeallofthecontentsfromthecarton.Seetheimportantnotesabove.Removetheoldxturefromthewall,includingtheold

mountingstrap.

1.Takethemountingstrapassemblyfromthepartsbag.Mountingstrap(B)containsthreadedholes.Twoofmountingscrews(A)

shouldbeattachedtomountingstrap(B).Youmayneedtotightennuts(C)thatholdthesescrewsinplace.Ifthescrewsarenot

CONNECTING THE WIRES

3.Haveanassistantsupportthexture’sweightwhilecompletingthewiring.Refertothewiringdiagrambelowandattachthexture’s

wirestothepowersupplywiresfromthejunctionbox.ConnectHottoHot,NeutraltoNeutral,andGroundtoGround.Twisttheends

ofthewirepairstogether,andthentwistonawireconnector.Makesurealltwistsareinthesamedirection.Ifthereisnohouseground

wirecomingfromthejunctionbox,locategroundscrew(E)onthemountingbracket/mountingstrapandwrapthexture’sground

wirearoundthegroundscrew.Useascrewdrivertotightenthetopofgroundscrew(E)ontothewiresandintothemountingbracket/

mountingstrap.Tuckthewiresintothejunctionbox.

AssemblyInstructions:2712-BA1 (Hollis)

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the

6.Installalightbulb(notincluded)inaccordancewiththexture’sspecications.Donotexceedthemaximumrecommendedwattage.

Yourinstallationisnowcomplete.Turnonthepowerandtestthexture.

How to Identify the Fixture’s Wires

Hot Neutral Ground

Smooth

Ribbed

Bare Metal,

Green, or

Green Inner

Thread

Thread