Psion Teklogix ST4002 Quick start guide

Brand
Psion Teklogix
Model
ST4002
Category
Notebook docks & port replicators
Type
Quick start guide
Choose a plug for the universal power adaptor. The
adaptor may already be tted with the plug you need.
Features: Front
Docking connector
Spare battery well
Features: Back and Battery Charge Well
GETTING STARTED
Insert the spare battery.
4
Over
Battery connector
Release button
Omnii™ compartment
Spare battery charge well
LED indicator
Insert the hand-held to charge its battery.
3
Note:
Use only the univer-
sal AC power supply
approved by Psion
Teklogix for use with
the Docking Station.
Note: Full battery performance is only reached after
the rst few charge/discharge cycles.
3 h
0 - 40 °C
32 - 104 °F
1
2
Connect the Docking Station to external power.
DC Input
Slide the hand-held computer
into the Docking Station until
it latches.
- During charge, the LED indicator on the
hand-held ashes GREEN.
- When nished charging, the indicator
displays solid GREEN.
- The LED indicator on the Docking Station
behaves the same when a spare battery
is being charged.
Docking connector
Features: Rear Ports
Allow the hand-held computer and the spare bat-
tery to charge for three hours before rst use.
5
ST4002
ST4003
DC In port
Client USB port
Host USB port
Client USB port
Host USB port
DE9M Serial port
RJ45 Ethernet port
Omnii™ compartment
Locking arm
The ST4002 and ST4003 Desktop Docking Stations feature:
- Fast charging of the Omnii™ internal battery.
- Fast charging of the spare battery pack.
- A Host USB port to connect peripherals such as a printer, keyboard, etc.
- A Client USB port to connect the docking station to a PC.
The ST4003 Desktop Docking Station additionally provides:
- A DE9M serial port (unpowered).
- An RJ45 10Base-T Ethernet interface. Both these interfaces are compatible with the
USB to Ethernet/serial drivers included in Omnii™.
Features: Operation
Place the battery contacts down to mate with the connector,
and pivot the battery into place in the battery charge well.
.
1. Press the button on the power adaptor to release the plug.
2. Slide the existing plug out of the adaptor.
3. Slide the desired plug into the adaptor until it clicks.
8000203A.indd 1 7/19/2010 4:44:47 PM
ISO 9001 Certied
Quality Management System
Quick Start Guide
Rev. A
Psion Teklogix and Omnii
are a trademarks of Psion
Teklogix Inc. Other product
names mentioned in this
document are trademarks
or registered trademarks of
other hardware, software,
or service providers and are
used herein for identication
purposes only.
Omnii™ Desktop Docking Stations
ST4002 and ST4003
8 0 0 0 2 0 3
To connect the Docking Station to a host computer:
USB Host computer
The hand-held computer in the Docking Station acts as a USB Client.
1. Connect the smaller end of the USB cable to the Docking Station (ST4002 shown).
2. Connect the at end of the USB cable to the host computer.
Contents of the Box:
The Docking Station
Power adaptor and plugs
USB Micro-B to Type A cable
This Guide
I
S
O
9
0
0
1
C
e
r
t
i
f
i
e
d
�
Q
u
a
li
t
y
M
a
n
a
g
e
m
e
n
t
S
y
s
t
e
m
ST4002 and ST4003
Omnii™ Desktop Docking Stations
Quick Start Guide
Charge LED Behaviour Function
OFF No battery detected.
Solid Green Battery charging complete.
Flashing Green Charge in progress.
Flashing Yellow Battery is not charging due to out-of-temperature
conditions.
Solid Red Unable to read battery or non Psion Teklogix
battery.
Docking Station Battery Charge LED Behaviour
July 19, 2010 PN 8000203.A
8000203A.indd 2 7/19/2010 4:44:50 PM
  • Page 1 1
  • Page 2 2

Psion Teklogix ST4002 Quick start guide

Brand
Psion Teklogix
Model
ST4002
Category
Notebook docks & port replicators
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents