PANEL VIEW & FUNCTION
INSTALLATION VIEW
SPECIFICATIONS
Cable
CE labs recommends the use of high quality CAT5eCAT6, CAT6a, CAT7 UTP/STP or
FTP cable. The best results for extension distance and picture quality are achieved with a
better quality cable and properly installed RJ-45 terminated connectors.
IR Switch Setting
1. When the system is congured to send IR signals to the remote display site, set the
Transmitter IR to TX and connect a controller (IR pickup) to this IR jack. Set the Receiver to
IR RX and connect an IR Emitter to the IR jack.
– OR –
2. When the system is congured to send IR back from the display site to the source, set the
Transmitter IR to RX and connect an IR Emitter to the IR jack. Set the Receiver to IR TX and
connect an IR pickup or controller to the IR jack.
RJ45 Dene: Video Link (TIA/EIA-568-B)
1. Orange-White DATA0 +
2. Orange
DATA0 –
3. Green-White
DATA1 +
4. Blue
DATA2 +
5. Blue-White
DATA2 –
6. Green
DATA1 –
7. Brown-White
DATA3 +
8. Brown
DATA3 –
Caution
1. Keep cables away from equipment with an electromagnetic wave, e.g., mobile
2. This device is not a network device, do not connect with a network
3. Do not place the IR Transmitter close to or pointing at the IR Receiver
4. The HX70M receiver unit has a normal working temperature that is warm to the touch.
Install in a location with sufcient ventilation and avoid stacking multiple receivers.
phone, microwave, radio equipment, uorescent lamp, high voltage power, etc.
HX70M TransmitterITEM
Up to 1080p@60Hz@48bits, 3D, 4K x 2K
60M (1080p) by CAT5e/6, 40M (4K*2K) & 70M (1080p) by CAT6
LPCM 7.1 192KHz, Dolby TrueHD, DTS-HD MA
HDMI Type A x 1
30 – 60Khz
± 15°
RJ45 x 1
HDMI Video Support
Extension Distance
HDMI Audio Support
Input/Output Interface
IR Carrier Frequency
IR Angle
5m / Bi-directional
HX70M Receiver
IR Distance
HDBaseT Connector
Transmitter
Receiver
Power Supply
Power Consumption
Temperature
Dimension (mm)
Weight (g)
Max 3W, Low Power 0.8W Max 6W, Low Power 1W
Operation: 0 to 55
o
– Storage: -20 TO 85
o
– Humidity: up to 95%
DC 5V 2A
49 x 92.3 x 25
125
49 x 92.3 x 25
135
Package Contents
HX70M HDMI Transmitter x 1
HX70M HDMI Receiver x 1
IR Emitter Cable x 1
IR Receiver Cable x 1
Mounting Screw pack x 2
Power Adapter x 2
Transmitter Receiver
PS3
DVR
Computer
70M (max)
CAT6a Cable
TV
± 55°
LED Indication
GREEN Power
BLUE Linking
BLUE Flashing Low-Power Mode
Low-Power Mode
1. When there is no HDMI video signal input or a TV is not connected or the TV power is off,
this product will enter a low-power mode to save power consumption; while under a low
power mode, it still provides Ethernet, RS-232, IR, and CEC signal transmission.
Transmission Distance
CAT6a 70M
< 5M < 5M
Transmitter
Wall Jack Wall Jack
Receiver
HDBaseT Distance Chart by Cable Type:
CAT.5e/CAT.6 60M
CAT.6a/CAT.7 70M
CAT.5e/CAT.6 35M
CAT.6a/CAT.7 40M
≤ 225MHz
> 225MHz
≤ 5.3Gbps
(Full HD Video)
> 5.3Gbps
(Ultra HD Video)
1080p 60Hz 36-bit
1080p 60Hz 48-bit
1080p 60Hz 3D, 4K*2K 30Hz
Cable Type Range Pixel Clock Ratio Video Data Rate Supported Video