LAUNAM NOITCURTSNI
Component Video/Audio
Distribution Amplifier
HDTVCompatible
AV901COMP
Doc: AV901Comp_manual.pdf
930_5006_01_REV.B_
KEY INFORMATION:
The AV901Comp allows any audio/video source, with
Y, Cb, Cr, or Y, Pb, Pr component outputs, to distribute
audio and video to nine different locations without
signal loss. This unit can be looped, cascaded, or put in
tandem, as shown below, without loss of audio/video
signals to multiple TVs.
The distribution of the Audio/VIdeo from a single ource to
multiple locations without any signal loss
CE labs can support many areas of your audio and video
distribution needs.
We manufacture:
• Digital Signage software and Media Players
• HD Matrix Switchers
• RF amplifiers
• HDMI and Component HD distribution amplifiers
• CAT 5 Signal Extenders
• VGA Extenders and Splitters
• and cables of all types.
See our full product line at
www.celabs.net
WARRANTY
Cable Electronics, Inc. warrants this product to be free from defects in
material and workmanship, under normal use and service, for a period of
one year from the purchase by the original purchaser. If this product is
defective or malfunctions, Cable Electronics will replace or repair this unit
(at their option) within a reasonable time. No expressed or implied warranty
is made for any defects caused by immersion or exposure to liquids, abuse,
neglect, improper operation of unit, excess wear and tear and defects
resulting from unauthorized disassembly and or modification.
3209 Wood Drive
Garland, TX 75041
Phone: (469) 429-9200
Toll free: (800) 767-6189
Fax: (469) 429-9205
www.celabs.net
AV901COMP
The AV901HDCOMP has one set of inputs and eight sets of outputs
and a loop-thru This unit allows any audio/video source, with Y,
Cb, Cr or Y, Pb, Pr component application outputs to distribute
audio and video to nine different locations without any signal
loss.
Key Information:
Any TV used must have the same application as your audio
video source. (Y, Cb, Cr and or Y, Pb, Pr.)
A/V input/output jacks: RCA type phone jacks.
Safety Instructions:
Location: Avoid locations with strong vibrations, direct sunlight or
intense heat
Avoid Electrical Shock: Do not handle power cord with wet hands;
do not expose to rain or other moisture. If liquid is spilled on unit,
unplug and have unit serviced at authorized service center.
To reduce the risk of electrical shock, do not remove cover. No
user-serviceable parts inside
SPECIFICATIONS
VIDEO
Nominal input level: 1 Volt peak to peak
Gain: 1 VOlt into 75ohms
(2 Volts Unterminated)
Input Impedance: 75 ohms
Output Impedance: 75 ohms
Isolation Port to Port: 32 dB
Return Loss: 18 dB
Video Bandwidth: > 50 MHz (HDTV requires 37MHz min.)
AUDIO
Nominal Input Level: 1 Volt peak to peak
Gain: Unity (one to one)
Input Impedance: 44k ohm
THD: 0.05%
Frequency Response: 20Hz to 100kHz
Channel Separation: >60dB
Port to Port Isolation: 60dB
Out to In Isolation: 60dB
Out to In Isolation: 60dB
Signal to Noise: 100dB @ 2 Volts out
POWER
Requirement: External 9 or 10 Volt AC @ 500mA with a 2.1mm
coaxial center pin connector. Power supply is included.
Any Audio/Video Source
such as a DVD VCR Etc.
Video
Y
Cb
Cr
L
R
BITSTREAM PCM
ANALOG
V DEO OUT
AUDIO OUT
To 4 additional TVs
To 4 additional TVs
The number 9 output can be used as
a loop-through to another AV
901COMP (as shown above) or you
can use it for the ninth TV. For best
result no more than twenty-five feet
between units.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
C2G 41065 Owner's manual
-
-
Cable Electronics AV501HDXi User manual
-
-
-
-
-
-
-