2. Molift
  3. Partner 255

Molift Partner 255, Mover 205, Mover 300 Operating instructions

  • Hello! I've reviewed the instructions for mounting the Ambulating arm stopper 1420021. This document includes steps for adjusting the ambulating arm, marking the column for drilling, and securing the stopper using bolts and a rubber stop. I'm ready to assist you with any questions you have about the installation process.
  • What is the first step in mounting the stopper?
    What is the height the ambulating arm should be adjusted to?
    What size drill hole should be made?
    What is the next step after drilling the holes?
195
AA
1221
25
M6
SECTION A-A
SCALE 1 : 2
Ø5
drill trough outer wall
Ø5
drill trough outer wall
25
M6
How to mount stopper
EN
Mover 205,300
Partner 255
art:1420021- Ambulating arm stopper
BM1201 2019-06-18 Rev A
195
AA
195
AA
1221
25
M6
SECTION A-A
SCALE 1 : 2
Ø5
drill trough outer wall
Ø5
drill trough outer wall
25
M6
195
AA
1221
25
M6
SECTION A-A
SCALE 1 : 2
Ø5
drill trough outer wall
Ø5
drill trough outer wall
25
M6
1 2 3 4
• Remove battery
• Adjust ambulating arm to 195 mm above
top of battery case.
• Set a mark on both side of column at A-A
• Set the ambulating arm to upper posistion
• Make a mark 25 mm from the column edge
at the previos marked height. Do this on
both sides of columb
• Drill a Ø5 hole trough the outer wall of co-
lumb. Do this on both sides of columb
• Make M6 threds in both holes.
• Insert bolt (1) into rubber stop (2). Screw
bolt into columb and tighten.Do this on both
sides of columb
• Innsert battery, then lower ambulating arms
until it stops against the rubber stop. Make
sure it is possible to remove the battery.
1
2
3
4
195
AA
/