2. Molift
  3. Mover 300

Molift Mover 300, Mover 205, Partner 255 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Molift Mover 300 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
195
AA
1221
25
M6
SECTION A-A
SCALE 1 : 2
Ø5
drill trough outer wall
Ø5
drill trough outer wall
25
M6
How to mount stopper
EN
Mover 205,300
Partner 255
art:1420021- Ambulating arm stopper
BM1201 2019-06-18 Rev A
195
AA
195
AA
1221
25
M6
SECTION A-A
SCALE 1 : 2
Ø5
drill trough outer wall
Ø5
drill trough outer wall
25
M6
195
AA
1221
25
M6
SECTION A-A
SCALE 1 : 2
Ø5
drill trough outer wall
Ø5
drill trough outer wall
25
M6
1 2 3 4
• Remove battery
• Adjust ambulating arm to 195 mm above
top of battery case.
• Set a mark on both side of column at A-A
• Set the ambulating arm to upper posistion
• Make a mark 25 mm from the column edge
at the previos marked height. Do this on
both sides of columb
• Drill a Ø5 hole trough the outer wall of co-
lumb. Do this on both sides of columb
• Make M6 threds in both holes.
• Insert bolt (1) into rubber stop (2). Screw
bolt into columb and tighten.Do this on both
sides of columb
• Innsert battery, then lower ambulating arms
until it stops against the rubber stop. Make
sure it is possible to remove the battery.
1
2
3
4
195
AA
/