Page is loading ...
What’s Included:
A-Pillar Pod
Bolt
GT POD Adapter
Part# 32303 Works On:
Dodge Ram
2003- 2009
GT Head Unit
GT Custom Pod Adapter
Custom Gauge Pod
(To OBDII Adapter Plug)
Main Harness
Main Harness Plug
Questions about installation or product details? Contact our Tech
Support team at 940-783-9914
Custom A-Pillar Pod
Installation Instructions
STEP 1:
Using a 10 mm socket, remove the bolt that holds the stock
A pillar in place. The bolt is located about halfway down the
pillar behind a small oval cover that will need to be removed.
STEP 2:
Pull out the weather stripping around the A-pillar (so it can be moved easily).
STEP 3:
Run cables as needed through the dash through the custom pod gauge hole. If installing another tuner
install the appropriate pod adapter at this time. LWTS+ requires part # 30604 and GTX requires part #
30605, which is not included. Follow instructions on installing the located on the inside of the
packaging card.
32303-99_v2.0
Questions about installation or product details? Contact our Tech
Support team at 940-783-9914
STEP 4:
Peel the clear strip(s) off the adhesive
tape on the back of the pod mount. Next,
position the custom gauge pod over the
stock A-pillar. (Do not attach or secure
it yet.)
STEP 5:
Route all wiring under the gauge pod (and under the dash, if necessary) and then slide the pod down until the
pod screw hole lines up stock screw hole.
Be careful not to touch the pod to the pillar (adhesive tape).
STEP 6:
Finally, use the provided bolt (not the stock bolt) secure the gauge pod and the stock A-pillar to the vehicle
frame. Firmly press down on the parts of the pod mount where the adhesive tape touches the stock A-pillar
and re-secure the weather stripping.
/
