ESAB Bayonette Style Adaptors User manual

Be sure this information reaches the operator.

You can get extra copies through your supplier.

Bayonette Style Adaptors

for

ESAB GunMaster 250 & 400

INSTRUCTIONS for

F-15-638-OR

September, 2000

These INSTRUCTIONS are for experienced operators. If you are not fully familiar with the principles of operation and safe

practices for arc welding equipment, we urge you to read our booklet, "Precautions and Safe Practices for Arc Welding, Cutting,

and Gouging", Form 52-529. Do NOT permit untrained persons to install, operate, or maintain this equipment. Do NOT attempt to

install or operate this equipment until you have read and fully understand these instructions. If you do not fully understand these

instructions, contact your supplier for further information. Be sure to read the Safety Precautions on pages 3 and 4 before

installing or operating this equipment.

Bayonette Adaptor

PN -2075378 and 2075379

If your Wire Feeder uses Bayonette adaptor No. 2075378

or 2075379 (as shown at right) it is necessary to change

the power pin as described below.

This change is necessary to insure that the locking pin

secures the torch in position for gas flow.

Loosen conduit nut and remove liner.

Using proper size wrenches remove existing

power pin.

Install new pin NO. 0558002313 “Included”.

Re-Install liner (Note: tighten liner nut snug with a

wrench.)

Power Pin P/N 0558001637

(Fitted to torch assy.)

Power Pin P/N 0558002313

(Supplied for use with Bayonette Adaptors.)

Locking Pin