Vivo MOUNT-VP05W Assembly Instructions
- Category
- Projector mounts
- Type
- Assembly Instructions
White Projector Ceiling Mount
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
Instruction Manual
https://vivo-us.com/products/mount-vp05w
SKU: MOUNT-VP05W
2
PACKAGE CONTENTS
TOOLS NEEDED
Phillips
Screwdriver
A (x1)
Pole
B (x1)
Plate
M-A (x4)
M3x25
Drill
M-B (x4)
M4x25
C (x4)
Arm
M-C (x4)
M5x25
M-D (x4)
M6x25
M-E (x4)
Washer
M-F (x8)
Washer
M-G (x4)
Bolt
M-H (x8)
Spacer
M-I (x1)
Allen Key
W-A (x5)
Screw
W-B (x5)
Anchor
W-C (x4)
Washer
66lbs
(29.94kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING!
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
NOTE: SOME HARDWARE INCLUDED MAY NOT BE USED
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR CEILING CONSTRUCTION. USE WOOD STUDS
TO MOUNT. We include mounting for brick and concrete. If unsure, please contact us at vivo-us.com,
email at [email protected]om, or call us at 309-278-5303.
3
ASSEMBLY STEPS
STEP 1
Attach arms (C) to plate (B) using (M-G) bolts and (M-F) washers. Align arms to mounting holes in
projector and tighten using (M-I) Allen key.
STEP 2
Mount projector to assembly using appropriate bolts and washers. Use (M-H) spacers if needed.
M-G
M-F
M-I
M-A/M- B
M-C/M- D
M-E/M- F
M-H
4
STEP 3
Route cables through pole (A).
STEP 4
OPTION A: Drywall/Wood Stud Installation
Use top plate of pole (A) to mark hole placement. Using 3/16” bit, drill 2.2” into ceiling stud. Mount pole
(A) to ceiling using (W-A) screws and (W-C) washers.
*Use of a stud finder is recommended.
N
P
O
W-A
W-C
3mm
u
W-A
5
STEP 4 (Continued)
OPTION B: Concrete/Brick Wall Installation
For concrete ceiling installation use a pencil to mark drilling locations, and drill 2-3/8” deep holes
using a 3/8” bit. Mount part (A) to ceiling using (W-A) screws, (W-B) anchors, and (W-C) washers.
STEP 5
Remove small bolt from bottom of pole (A). Slide projector onto pole, and secure with previously
removed bolt.
O
N
W- A
3m m
W- B
W- A
W- C
6
STEP 6
Adjust height and tilt angle of pole (A) using Allen key (M-I).
90 °
0°
7
STEP 7
Tilt and rotate projector for best image projection.
360 °
20°
-20°
20°
-20°
LAST UPDATED: 01/15/2020
Open Monday-Friday from 7:00am-7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times.
If any parts are received damaged or defective, please contact us.
We are happy to replace parts to ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
www.vivo-us.com
309-278-5303
AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
AVG. RESOLUTION TIME (within oice hrs): < 15 M
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Vivo MOUNT-VP05W Assembly Instructions
- Category
- Projector mounts
- Type
- Assembly Instructions
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Vivo MOUNT-VP06B User manual
-
-
-
-
Vivo MOUNT-VP01B User manual
-
-
-
-
-
