3W SMD LED RECHARGEABLE BULB
MODEL NO: LED3WB
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
PLEA
E READ THE
E IN
TRU
TI
N
AREFULLY. N
TE THE
AFE
PERATI
NAL RE
UIREMENT
, WARNIN
AUTI
N
. U
E
T
RRE
TLY AND WITH
ARE F
R THE P
RP
E F
R WHI
H IT I
INTENDED. FAIL
RE T
D
MAY
A
E DAMA
E AND
R
AL IN
RY AND WILL INVALIDATE THE WARRANTY. KEEP TH
IN
AFE
R F
T
RE
.
1. SAFETY
Ensure the lamp is fully charged before initial use.
DO NOT charge in damp conditions.
DO NOT turn the LED rechargeable bulb on when it is being charged.
DO NOT shine directly into your, another person’s or an animal’s eyes.
DO NOT allow children to use the LED rechargeable bulb.
DO NOT handle or move the LED rechargeable bulb whilst it is being charged.
DO NOT use the LED rechargeable bulb if you suspect that the battery or the lamp casing is damaged.
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
recharge the battery at least once every six months of non-use.
DO NOT attempt to open, disassemble, modify or service the battery pack.
DO NOT crush, puncture or dispose of in fi re or water.
Maintain the LED rechargeable bulb in good condition.
Store the LED rechargeable bulb in the original box, in a safe, dry, childproof area.
2. INTRODUCTION
Rechargeable LED bulb ideal for camping or emergency situations. Operates 14 SMD LEDs that feature four selectable light settings.
Features 3.7V 1.2Ah Li-ion rechargeable battery for up to 3 hours operating time on its highest setting. Produces up to 170 lumens. Built-in
hanging hook for hands-free applications.
3. SPECIFICATION
Model No: ............................................................... LED3WB
Battery: .......................................................3.7V 1.2Ah Li-ion
Charging time:................................................................4-5hr
Functions: ...............................................High/Med/Low/Blink
LED type: ...................................................... 14 x 0.2W SMD
Lumen output: ...........................High/Med/Low - 170/80/40lm
Operating time: ...................................................... High - 3hr
Power: .............................................................................. 3W
4. OPERATION
Unpack the product and check contents. Should there be any damaged or missing parts contact your supplier immediately.
4.1. CHARGING THE LED RECHARGEABLE BULB
4.1.1. Insert the Micro USB cable into the USB slot located on the top of the LED rechargeable bulb.
4.1.2. Insert the other end into either a USB wall charger, a car accessory charger or the USB port on a computer (none supplied).
4.1.3. When charging the indicator light will display red.
4.1.4. When fully charged the indicator light will change to display green.
4.1.5. Disconnect from the charging source.
DO NOT leave the LED rechargeable bulb on charge for long periods.
4.2. TURNING THE LED RECHARGEABLE BULB ON AND OFF
4.2.1. The ON/OFF button is located on the top of the LED rechargeable bulb.
4.2.2. Press the button once for HIGH brightness, then press the button further through until BLINK. Press once more to turn the LED
rechargeable bulb off .
5. MAINTENANCE
5.1. After usage recharge the LED rechargeable bulb.
5.2. Use a clean, dry cloth to wipe down the LED rechargeable bulb after use.
DO NOT use solvents to clean the LED rechargeable bulb.
LED3WB Issue 1 20/07/21
Original Language Version
© Jack Sealey Limited
Refer to
instructions