2. Fishbone Offroad
  3. FB31043

Fishbone Offroad FB31043 Installation guide

  • Hello! I'm a chat assistant and I've reviewed the installation instructions for the Fishbone Offroad Taillight Covers for the Jeep JK Wrangler. This document explains how to install the covers step by step, including removing existing covers, using the correct screws, and not overtightening them. I'm ready to answer your questions about this process.
  • What tools are required for installation?
    What is the difference between the screws?
    What precautions should I take during installation?
FB31043
Jeep® JK Wrangler
Fishbone Offroad Taillight Covers
3104300
REQUIRED TOOLS
Phillips Screwdriver
KIT CONTAINS
Taillight Cover
No. 8 Screw
No. 10 Screw
Plastic Spacer
QTY
2
4
4
8
1) REMOVE TAILLIGHT SCREWS
Remove your OEM or existing taillight cover using
the Phillips screwdriver.
2) INSTALL TAILLIGHT COVER
CAUTION!
THE SCREWS CLOSEST TO THE TAILGATE ARE NO. 8,
AND THE SCREWS ON THE OUTSIDE OF YOUR JEEP
ARE NO. 10. TAKE CARE TO NOT MIX THESE UP TO
AVOID DAMAGE TO YOUR TAILLIGHT HOUSINGS!
Install two No. 8 screws and spacers into the holes
closest to the tailgate. Ensure the spacers are
between the taillight cover and your taillight. Install
two No. 10 screws and two spacers into the outside
holes.
Tighten screws with the screwdriver. DO NOT
OVERTIGHTEN!
3) REPEAT ON OPPOSITE SIDE
4) ENJOY YOUR NEW FISHBONE OFFROAD TAILLIGHT
COVERS!
/