2. SKYDANCE
  3. EB-C

SKYDANCE EB-C, ED-C User manual

  • Hello! I've reviewed the user manual for the EB-C and ED-C sensing heads. These sensors are designed for hand sweep and door control, offering features like a 1-second light fade, a 1-6 cm sensitivity range, and PWM signal output. I'm ready to answer any questions you have about these devices.
  • What is the sensitive field of the sensor?
    What is the sensitive angle of the sensor?
    What is the output PWM frequency?
    What voltage powers the sensor?
ED-C,EB-C
Page1
Sensor
2023.8
User Manual Ver 1.0.0
Wire length:1 meter
Sensor wire dene
S
+
Powerinput+
5V level or PWM signal,
high is ON, low is OFF
Model Product name Product picture Sensor data
Door sensing head
ED-C
Powerinput -
● Concealed aluminum housinghand sweep /door control sensing head.
● Powered by low voltage 5VCD, output 5V level or PWM signal.
● Output PWM frequency: 2000Hz.
● 1 second on/off light fade.
● Apply to cabinet, closet, wine cabinet and other lighting.
Features
Hand Sweep / Door Control Sensing Head
Sensitiveeld:1-6cm
Sensitiveangle:15-25
Sensing head installation
When the door open, or no obstacle in front of the sensing head,
the light turn on gradually;
When the door close, or obstacle in front of the sensing head,
the light turn off gradually.
ED-C: Door sensing headEB-C: Handsweep sensing head
Make pendulum action at the front end of the sensing head:
when hand sweep, the light turn on gradually;
when hand sweep again, the light turn off gradually.
Hold your hand in front of the sensing head for more than 2 seconds:
The brightness increases or decreases continuously,
the each time the hand is removed and then held again,
the brightness changes in the opposite direction.
1. Make a 20mm diameter hole. 2. Place the sensing switch into the hole.
18mm
26mm
Hole diameter
20mm
Drilling depth
16mm
26mm
26mm
Sensing head application
EB-C Hand sweep sensing head
Sensitiveeld:1-6cm
Sensitiveangle:15-25
/