SCE SCE-TSH150 Installation Information

Brand
SCE
Model
SCE-TSH150
Type
Installation Information

This manual is also suitable for

FT2 AREA TSH-25 TSH-50 TSH-75 TSH-100 TSH-150
0 – 8 One
9 – 16 One
17 – 24 One
25 – 32 One
33 – 40 One
41 – 48 One
49 – 56 One
57 – 64 One
65 – 72 One
73 – 80 One
81 – 88 One
89 – 120 One
1.61”
1.61”
4.92”
5.51”
2.48”
2.76”
8.66”
2.76”
2.76”
MODEL SELECTION:
• Determine the surface area of the enclosure in square feet.
• Select the Touch Safe Heater unit from
the chart based on square feet of the enclosure.
• Units should be installed in the lower quarter of the enclosure.
• When enclosure width is greater than height, two smaller
units will heat the area more efficiently than one larger unit.
SURFACE AREA EQUATION:
2[(Height x Width)+(Height x Depth)+(Width x Depth)] ÷ 144
HEATER ELEMENT
SUPPLY
CONNECTOR N L
2 1
BK
AWG18
RD
AWG18
• All heaters are delivered with a DIN rail Clip 1.37”.
• Maximum Surface Temperature on casting: 80C/176F.
• 4.75” Minimum Thermal Safety gap required
above or to side of this device.
Touch Safe Heaters
SCE-TSH25 & SCE-TSH50
SCE-TSH75 & SCE-TSH100
SCE-TSH150
CIRCUIT DIAGRAM
NOTES
  • Page 1 1

SCE SCE-TSH150 Installation Information

Brand
SCE
Model
SCE-TSH150
Type
Installation Information
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents