2. SCE
  3. SCE-TSH100

SCE SCE-TSH100, SCE-TSH150, SCE-TSH25, SCE-TSH50, SCE-TSH75 Installation Information

  • Hello! I've reviewed the datasheet for the Saginaw Control Touch Safe Heaters, which include models SCE-TSH25, SCE-TSH50, SCE-TSH75, SCE-TSH100, and SCE-TSH150. This document provides important details regarding installation, model selection based on enclosure size, and safety precautions such as the required thermal safety gap. I'm ready to address your questions about these heaters and their use.
  • What is the maximum surface temperature of the heaters?
    What is the minimum thermal safety gap required for these heaters?
    Where should the heaters be installed in an enclosure?
    What should be done if the enclosure's width is greater than its height?
FT2 AREA TSH-25 TSH-50 TSH-75 TSH-100 TSH-150
0 – 8 One
9 – 16 One
17 – 24 One
25 – 32 One
33 – 40 One
41 – 48 One
49 – 56 One
57 – 64 One
65 – 72 One
73 – 80 One
81 – 88 One
89 – 120 One
1.61”
1.61”
4.92”
5.51”
2.48”
2.76”
8.66”
2.76”
2.76”
MODEL SELECTION:
• Determine the surface area of the enclosure in square feet.
• Select the Touch Safe Heater unit from
the chart based on square feet of the enclosure.
• Units should be installed in the lower quarter of the enclosure.
• When enclosure width is greater than height, two smaller
units will heat the area more efficiently than one larger unit.
SURFACE AREA EQUATION:
2[(Height x Width)+(Height x Depth)+(Width x Depth)] ÷ 144
HEATER ELEMENT
SUPPLY
CONNECTOR N L
2 1
BK
AWG18
RD
AWG18
• All heaters are delivered with a DIN rail Clip 1.37”.
• Maximum Surface Temperature on casting: 80C/176F.
• 4.75” Minimum Thermal Safety gap required
above or to side of this device.
Touch Safe Heaters
SCE-TSH25 & SCE-TSH50
SCE-TSH75 & SCE-TSH100
SCE-TSH150
CIRCUIT DIAGRAM
NOTES
/