Instruction manual
5
USING INSTRUCTIONS
Before using for the first time
- Unwrap the product, make sure your remove all packaging materials.
- Wipe parts clean with a damp towel.
- Familiarize yourself with each part.
Attention: Do not add water when sharpening knife, scissor, screwdriver, otherwise will cause the risk
of electric shock.
How to sharpen the knife:
Place the appliance on a stable surface.
Pull out the cord and plug in with the outlet.
Press the switch, motor will drive the grinding wheel running up.
Hold the handle and put the edge to the “V” groove, pull out the knife at
even speed until the edge reach the bottom of the groove, repeat
sharpening 3-4 times. (Put the edge as close to the front
as possible, then the whole edge can be sharpened).
- “V” groove in picture 1-2 are coarse sharpening.
- picture 3-4 are fine sharpening.
- Picture 1 and 3 for sharpening the right edge, picture 2 and 4
for sharpening the left edge.
You can choose coarse or fine sharpening according to the sharpness of the
edge, can coarse-sharpen and then fine-sharpen if the edge is duII. This
will shorten the time of sharpening. You only need to fine-sharpen if the
edge is not very dull.
Turn off the switch and cut off the power.
Clean the table and the appliance, finish sharpening.
Tips and Hints
Pull out the knife at even speed to get better sharpening.
-
Slightly adjust the angle of the edge in the “V” groove for close contact.
-
Press the appliance when sharpening, it will be more stable.
-
Motor will be hot after several cycles, must let the appliance cool off before
operate again.
How to sharpen the scissor:
Connect with power and press the switch
Open the scissor and hold one edge.