Aulta SEAWARD User manual

Type
User manual
USER MANUAL
WWW.AULTASURF.COM USER MANUAL PAGE 2
All AULTA watches are made of 100% hypoallergenic 316L stainless steel.
BATTERY LIFE
The battery of your AULTA watch should last approximately two years.
Please be sure to replace it as soon as it expires to prevent any malfunction
or damage to the piece.
LEATHER STRAPS
Our leather straps are made with the nest materials. Keep yours in pristine
condition by shielding it from direct sunlight for prolonged periods, which can
cause fading. Also, do not submerge leather straps in water.
ABOUT THE SCREW-DOWN CROWN
All AULTA watch models feature a screw-down crown; this component helps
prevent moisture inltration. Always be certain that your crown is completely
screwed down before entering any environment or before undertaking any
activities where moisture is present. Never unscrew your crown while in any
environment where moisture is present.
OPERATING THE SCREW-DOWN CROWN
In order to pull the crown out to the rst or second
locking position, it must rst be unscrewed.
To open the crown, simply turn the crown
counter-clockwise 4 to 5 turns. To close
the crown and screw it down, push it
in while turning clockwise; lightly
nger-tighten the crown. Do not
over-tighten the crown. The threading
of your AULTA screw-down crown
aids in effective moisture resistance.
By over-tightening the crown the seals,
gaskets and related materials can be damaged,
resulting in reduced moisture resistance.
CROWN POSITIONS
The AULTA screw-down crown has four positions:
One: Screwed down (closed): The crown of your watch is ready to wear and is
moisture resistant.
Two: Unscrewed (open): The crown of your watch is unscrewed and not moisture
resistant.
Three: Unscrewed, with crown pulled out to the rst notch (open): to set the hour
hand. The crown of your watch is unscrewed and not moisture resistant.
Four: Unscrewed, with crown pulled out to the second notch (open): to set the
date. The crown of your watch is unscrewed and not moisture resistant.
WATER RESISTANCE
Make sure the crown is screwed down completely before using your watch in or
near water.
Steam may compromise the watch’s water resistance, so it is best to keep it away
from hot tubs, saunas or hot showers.
Water resistance may decrease over time and with wear and tear, so please use
caution.
All AULTA watches are rated 10 ATM.
MARKING
RAIN AND
HANDWASHING SWIMMING SNORKELING SCUBA
NO NO NO NO
3 ATM YES NO NO NO
5 ATM YES YES NO NO
10 ATM YES YES YES NO
Tighten
Loosen
WWW.AULTASURF.COM USER MANUAL PAGE 3
Button A
24-hour hand
Button B
Calendar
Normal crown position
Chronograph
second hand
Hour hand Minute hand
Chronograph
minute hand
1 2 3
Crown
THE SEAWARD OPERATING INSTRUCTIONS
To set the time:
1. Unscrew and pull crown completely to position 3 (two clicks).
2. Turn crown counter clockwise to correct time.
3. Push in to position 1 and screw down crown.
To set the date:
1. Unscrew and pull out crown to middle position 2 (one click).
2. Turn crown counter clockwise to correct date.
3. Push in to position 1 and screw down crown.
To set the day:
1. Unscrew and pull out crown to middle position 2 (one click).
2. Turn crown clockwise to correct day.
3. Push in to position 1 and screw down crown.
THE LEEWAY OPERATING INSTRUCTIONS
To set the time:
1. Unscrew and pull crown completely to position 3 (two clicks).
2. Turn crown counter clockwise to correct time.
3. Push in to position 1 and screw down crown.
To set the date:
1. Unscrew and pull out crown to middle position 2 (one click).
2. Turn crown counter clockwise to correct date.
3. Push in to position 1 and screw down crown.
Using the chronograph:
This chronograph is able to measure and display time in 1/1 second united up to
maximum of 1 hour.
Measuring time with the chronograph:
1. The chronograph can be started and stopped each time button “A” is pressed.
2. Pressing button “B” resets the chronograph and all hands return to their 0
positions. Only push button “B” when the chronograph has stopped.
Resetting the starting position of the chronograph second hand:
1. Unscrew and pull the crown out to the 2nd position.
2. Push button A to set position of the chronograph second hand.
3. Once the hand has been set push back the crown on normal position and screw
down to seal.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Aulta SEAWARD User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI