Kichler Lighting 55025PN User manual

Type
User manual

This manual is also suitable for

IS-52229-US
Were here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
Fixture Diagram
Parts List
Cauons
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starng and during the installaon.
WARNING:
This xture is intended for installaon in accordance
with the Naonal Electrical Code (NEC) and all local code
specicaons. If you are not familiar with code requirements,
installaon by a cered electrician is recommended.
CLEANING:
Always be certain that electric current is turned o before
cleaning.
• Only a so damp cloth should be used. Harsh cleaning
products may damage the nish.
[A] Mounting
Strap
[B] Outlet Box
[C] Mounting
Screws
[D] Canopy
[E] Strap
Mounting
Screws
[F] Spacer
[G] Bulb
[H] Glass
[I] Socket Ring
[J] Bulb Cover
[K] Spanner Tool
1) Aach mounng strap[A] to outlet box[B] using the
strap mounng screws[E]. Mounng strap can be
adjusted to suit posion of xture.
2) Grounding instrucons: (See Illus. a or b).
a) On xtures where mounng strap is provided with a
hole and two raised dimples, wrap ground wire from
outlet box around green ground screw, and thread
into hole.
b) On xtures where a cupped washer is provided,
aach ground wire from outlet box under cupped
washer and green ground screw, and thread into
mounng strap.
If xture is provided with ground wire, connect xture
ground wire to outlet box ground wire with wire
connector aer following the above steps. Never connect
ground wire to black or white power supply wires.
3) Make wire connecons. Reference chart below for
correct connecons and wire accordingly.
Connect Black or Red
Supply Wire to:
Connect White Supply
Wire to:
Black White
*Parallel cord (round &
smooth)
*Parallel cord (square &
ridged)
Clear, Brown, Gold or
Black without Tracer
Clear, Brown, Gold or Black
with Tracer
Insulated wire (other
than green) with copper
conductor
Insulated wire (other
than green) with silver
conductor
*Note: When parallel wire (SPT
1 & SPT 2) are used. The neutral
wire is square shaped or ridged
and the other wire will be round
in shape or smooth (See illus.)
Neutral Wire
4) Push xture to wall carefully aligning the mounng
screw holes in the top and boom of the mounng strap
with mounng screw holes in the top and boom of
the canopy. NOTE: Fixture can be mounted with glass in
the up or down posion. Make sure all wires are inside
canopy and do not get pinched between canopy and
wall.
5) Screw in two (2) mounng screws[C]: one on top side of
canopy and one on boom side of canopy[D].
6) Carefully place the glass[H] over the socket to the
xture. Slip the smaller opening over the socket and t
the glass against the socket.
7) Place the spacer[F] over the socket and using the
spanner tool[K] thread the socket ring[I] onto the
socket. Tighten socket ring to secure glass in place. (DO
NOT over ghten). Do not discard the spanner wrench,
keep for future use if glass needs to be removed.
8) Insert recommended halogen bulb[G] (supplied). (Note:
Do not handle the bulb with bare hands).
9) Install bulb cover[J] over the installed bulb by twisng
into place, do not over ghten.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
a
b
Installaon Instrucons
H
B
A
C
D
E
I
G
J
K
F
  • Page 1 1
  • Page 2 2
  • Page 3 3

Kichler Lighting 55025PN User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI