Great Day UVPR901 Installation guide

Brand: Great Day

Model: UVPR901

Type: Installation guide

POWER-RIDEBOW HOLDER

MODEL: UVPR901

READ ALL INSTRUCTIONS BEFORE USING THE POWER-RIDE BOW HOLDER.

NOTE: Failure to read instructions before use could result in injury or death.

Instructions for Installation and Use:

Fig. 1

Fig. 3

Contents: See Fig. 1

1 –bow holder, 1 –mounting cradle,

2 – ½ “mounting bar, 2 – ¼” U-Bolts,

4 – ¼ " x 1 ¼ " bolts, 8 -1/4" locknuts,

12 -flat washers

1) Secure mounting bars to mounting

cradle using (4) ¼ " x 1 ¼ " bolts, (8) flat

washers, and (4) locknuts (Fig.2).

Tighten locknuts.

Fig. 3

Fig. 4 Fig. 5

Fig. 6 Fig. 7

NEVER USE "POWER-RIDE" BOW HOLDER TO CARRY ANYTHING OTHER THAN BOWS

i.e. GUN(S), AXES, KAISER BLADES, SHOVELS, ETC.

MAKE SURE BOW(S) ARE PROPERLY SECURED PRIOR TO MOVING VEHICLE.

NEVER TRY TO REMOVE BOW(S) FROM THE POWER-RIDE BOW HOLDER WHILE OPERATING VEHICLE.

For more information about this or other products, contact us at:

Great Day, Inc.

604 Kimbrough Dr. * Tallulah, LA 71282 * (866) 649-1918 * www.greatdayinc.com

2) Place bow holder on mounting bar and

secure using (2) ¼” U-Bolts, (4) flat

washers, and (4) 1/4" locknuts (Fig. 3).

Tighten locknuts.

3) Place the assembled Power Ride Bow Holder on the desired location on the vehicle (Fig. 4)

and secure in place by tightening the pre-installed wing knobs until the bow holder is centered

and secured (Fig.5).

4) To transport bow, push the handle located on the right U-shaped holding bracket inward to

create tension. Place bow limb in holding bracket, with strings down, and gently release the

handle (Fig. 6). Repeat above steps for left side. The resistance created from tension strap

will securely lock bow in place (Fig. 7).

Great Day UVPR901 Installation guide

Brand: Great Day

Model: UVPR901

Type: Installation guide

Download PDF

report

Great Day UVPR901 Installation guide

Great Day UVPR901 Installation guide

Related papers

Other documents