The “Power-Pak” Gun Rack
Model: 557
READ ALL INSTRUCTIONS BEFORE USING THE “POWER PAK” GUN RACK
NOTE: Failure to read instructions before use could result in injury or death.
Instructions for Installation and Use:
Fig. 1
Fig. 2
Contents: (Fig. 1)
1 -Gun rack frame
2 -Gun holding clips
2 -Mounting brackets
4 –Riv-Nut Plates
12 -1/4" x 1-3/4" bolts
4 -1/4" locknuts
8 -Flat washers
8 – ¼” x 2 ½” bolts
STEP 1 - Secure gun rack frame
mounting brackets using (4) Riv-Nut
Plates, flat washers, and locknuts.
Tighten bolts and locknuts (Fig.2)
Fig. 3
Fig. 4 Fig. 5
NEVER PLACE A LOADED GUN(S) INTO "POWER-PAK" GUN RACK.
NEVER USE "POWER-PAK" GUN RACK TO CARRY ANYTHING OTHER THAN UNLOADED
GUN(S) i.e. AXES, KAISER BLADES, SHOVELS…….
MAKE SURE GUN(S) ARE PROPERLY SECURED INTO GUN HOLDING CLIPS WITH VELCRO.
NEVER TRY TO REMOVE GUN(S) FROM THE (POWER-PAK) GUN RACK WHILE OPERATING
ATV OR UTV.
For more information about this or other products, contact us at:
Great Day, Inc.
604 Kimbrough Dr. * Tallulah, LA 71282 * (866) 649-1918 * www.greatdayinc.com
STEP 2 - Place gun rack frame into the gun
rack mounting brackets and secure with the 1/4"
x 1-3/4" bolts, flat washers and locknuts. (Fig.3)
3) Using (2) 1/4" x 1-3/4" bolts, flat washers, and locknuts attach gun clips to gun rack frame (Fig.4).
NOTE: select holes in gun rack frame for desired gun holding clips spacing. Gun clips with extra pads
are for the barrel end of gun. (Fig. 5) Tighten all hardware thoroughly.
/
