Copyright © 2016 Aqua Creek Products All Rights Reserved
Revised 3/2/16
PVC Wheelchair
9889 Garrymore Ln
Missoula, MT 59808
888-687-3552 | +1-406-549-0769
aquacreek.com
PART #: F-011PAC-MS
250 LB. [113 kg] MAXIMUM WEIGHT CAPACITY
MANDATORY – LEAVE THIS MANUAL WITH WHEELCHAIR OWNER
1
Copyright © 2016 Aqua Creek Products All Rights Reserved
Revised 3/2/16
PVC Wheelchair
The PVC Wheelchair will arrive in one box containing two dierent pieces and a bag of screws.
The larger piece, picture A, is the seat and wheels. The smaller piece, picture B, is the backrest and
armrest.
PICTURE A
PICTURE B
To attach the backrest to the seat, slide the backrest PVC tubing onto the tubing of the seat
assembly. See ‘Picture C’ and ‘Picture D’ below.
PICTURE C PICTURE D
2
Copyright © 2016 Aqua Creek Products All Rights Reserved
Revised 3/2/16
PVC Wheelchair
To attach the armrest to the seat assembly swing the armrest around until it is positioned just above
the connection tube on the seat assembly, then press down to set in place. See ‘Picture E’ and
‘Picture F’ below
PICTURE E PICTURE F
Secure the backrest assembly and seat assembly together with the supplied screws. One (1) screw
should go on either side of the frame in the pre-drilled holes. See ‘Picture G’ and ‘Picture H’ below.
PICTURE G PICTURE H
3
Copyright © 2016 Aqua Creek Products All Rights Reserved
Revised 3/2/16
PVC Wheelchair
Loop the end of the backrest fabric around the seat frame and tighten using the straps on either
end. Loop the one strap though the buckle end of the other strap and pull tight. See ‘Picture I’ and
‘Picture J’ below.
PICTURE I PICTURE J
Assembly is now complete and the wheelchair is ready for use. See ‘Picture K’ below for look of
nished assembly of the wheelchair.
PICTURE K
4
/
