DAN DRYER 50586 Installation guide

Type
Installation guide
INSTALLATION GUIDE
HEPA lter, 50584/50586 for
DAN DRYER hand dryers BJÖRK, TURBO Low Noise & AirTap
Introduction:
This guide shows how to properply install a DAN DRYER HEPA lter 50584/50586.
Warning:
To achieve the best possible result, it is important that the lter’s particle lter (green without ribs) is facing outward.
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • www.dandryer.com
BJÖRK
1. Locate the mounting holes on the foot of the
dryer. Remove existing lter holder, if any, before
the new unit can be installed.
2. Place the lter unit on the holes over the air
inlet.
3. Fit and fully tighten the security screws on
both sides.
4. Installation/replacement of the lter is now
complete.
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • www.dandryer.com
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • www.dandryer.com
TURBO Low Noise
1. Locate the mounting holes on the foot of the
dryer. Remove existing lter holder, if any, before
the new unit can be installed.
2. Place the lter unit on the holes over the air
inlet.
3. Fit and fully tighten the security screws on
both sides.
4. Installation/replacement of the lter is now
complete.
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • www.dandryer.com
AirTap
1. Locate the mounting holes on the foot of
the dryer. Remove existing lter holder, if any,
before the new unit can be installed.
2. Place the lter unit on the holes over the air
inlet.
3. Fit and fully tighten the security screws on
both sides.
4. Installation/replacement of the lter is now
complete.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

DAN DRYER 50586 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI