DAN DRYER 67020 Installation guide

INSTALLATION GUIDE

HEPA lter, 67020/67021 for

DAN DRYER LOKI hand dryer

DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • dandryer.com

Introduction:

This guide shows how to properply install a DAN DRYER HEPA lter 67020/67021.

DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • dandryer.com

LOKI

1. Locate the mounting holes on the foot of the

dryer. Remove existing lter holder, if any, before

the new unit can be installed.

2. Place the lter unit on the holes over the air

inlet.

3. Fit and fully tighten the security screws on

both sides.

4. Installation/replacement of the lter is now

complete.