2. DAN DRYER
  3. 50586
50586

DAN DRYER 50586 Installation guide

  • Hello! I'm here to assist you with your DAN DRYER HEPA filter model 50584/50586 installation. I have reviewed the installation guide, which details the steps for correctly installing the filter on BJÖRK, TURBO Low Noise, and AirTap hand dryers. The guide emphasizes the importance of proper orientation, with the green particle filter facing outwards. Feel free to ask any questions you may have about the installation process or the filter itself.
  • What is the correct orientation of the filter?
    What should I do before installing the new filter?
    How is the filter secured?
INSTALLATION GUIDE
HEPA lter, 50584/50586 for
DAN DRYER hand dryers BJÖRK, TURBO Low Noise & AirTap
Introduction:
This guide shows how to properply install a DAN DRYER HEPA lter 50584/50586.
Warning:
To achieve the best possible result, it is important that the lter’s particle lter (green without ribs) is facing outward.
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • www.dandryer.com
BJÖRK
1. Locate the mounting holes on the foot of the
dryer. Remove existing lter holder, if any, before
the new unit can be installed.
2. Place the lter unit on the holes over the air
inlet.
3. Fit and fully tighten the security screws on
both sides.
4. Installation/replacement of the lter is now
complete.
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • www.dandryer.com
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • www.dandryer.com
TURBO Low Noise
1. Locate the mounting holes on the foot of the
dryer. Remove existing lter holder, if any, before
the new unit can be installed.
2. Place the lter unit on the holes over the air
inlet.
3. Fit and fully tighten the security screws on
both sides.
4. Installation/replacement of the lter is now
complete.
DAN DRYER A/S • Alsikevej 8 DK-8920 Randers NV • +45 86 41 57 11 • info@dandryer.com • www.dandryer.com
AirTap
1. Locate the mounting holes on the foot of
the dryer. Remove existing lter holder, if any,
before the new unit can be installed.
2. Place the lter unit on the holes over the air
inlet.
3. Fit and fully tighten the security screws on
both sides.
4. Installation/replacement of the lter is now
complete.
/