24 7 GOLF Golf Simulator User manual

Hello! I've reviewed the assembly instructions for the 24:7 Golf Simulator Enclosure. This document provides detailed steps for setting up the enclosure, including attaching the material to the metal frame and tensioning the screen. It also emphasizes the importance of attaching the supplied padding to prevent injury and voiding warranty. I'm ready to answer any questions you have about this setup process or the features of the simulator enclosure.
What are the dimensions of the Golf Simulator Enclosure?

How is the enclosure material attached to the frame?

What is the front of the hitting screen like?

Golf Simulator Enclosure Assembly Instructions

3m x 2.6m x 1.6m / 10’ x 8’6” x 5’3”

Your Golf Simulator Enclosure will come in 2 Separate Cartons

1 x Long Carton - Metal Frame & 1 x Rectangular Carton - Enclosure Material with Screen

Long Carton - Metal Frame Contents

1 x Rectangular Carton - Enclosure Material with Screen

The enclosure material is a single piece construction containing the

projector screen, side panels and a ceiling panel.

Frame Assembly Part Identification

Step #1 - Assemble the Upper Frame

Step #2 - Attach the enclosure material to the metal frame

Place the material in the centre of your enclosure area and spread the black material out so that you can easily identify the bottom of the screen.

The front of your hitting screen that you hit into will be the smooth side.

Secure all 4 top edges of the enclosure material to the upper frame using the Velcro attachments.

Start at the rear, before moving on to each side, then do the front last

Once the top is secured, move around the enclosure and attach the enclosure to each of the vertical upright legs

Connect the 1A Poles - (Male-to-Female) to each of the four vertical uprights.

Once installed your enclosure will be around 8’6” (2.6m) tall.

Wrap and secure the remaining perimeter edges along all sides and the bottom lower frame

Tensioning the screen

Tightly loop and secure the vertical tensioning straps around the lower horizontal frame using the velcro strapping that comes from the top of the enclosure

Tightly secure the horizontal straps using the velcro strapping that comes from the side of the enclosure

IMPORTANT: ATTACH THE SUPPLIED PROTECTION PADDING TO THE VELCRO LOCATED AROUND THE INSIDE EDGE OF THE PROJECTOR SCREEN SO THAT THE PADS FULLY COVER THE CORNER SEAMS.

FAILURE TO ATTACH THE SUPPLIED PADDING WILL VOID WARRANTY AND MAY CAUSE INJURY

A time lapse video of this installation can be found at

https://youtu.be/ArNc_2Tc2ak

For further assistance please email play@247-golf.com