Epson P-4000 User manual

Category
PC/workstation barebones
Type
User manual
P-4000 Basics
P4000Basics.book Page 1 Thursday, August 18, 2005 8:26 AM
2
Copyright Notice
All rights reserved. No part of this publication may be reproduced, stored in a
retrieval system, or transmitted, in any form or by any means, electronic,
mechanical, photocopying, recording, or otherwise, without the prior written
permission of Seiko Epson Corporation. The information contained herein is
designed only for use with this Epson product. Epson is not responsible for
any use of this information as applied to other equipment.
Neither Seiko Epson Corporation nor its affiliates shall be liable to the
purchaser of this product or third parties for damages, losses, costs, or expenses
incurred by the purchaser or third parties as a result of accident, misuse, or
abuse of this product or unauthorized modifications, repairs, or alterations to
this product, or (excluding the U.S.) failure to strictly comply with Seiko
Epson Corporation’s operating and maintenance instructions.
Seiko Epson Corporation shall not be liable for any damages or problems
arising from the use of any options or any consumable products other than
those designated as Original Epson Products or Epson Approved Products by
Seiko Epson Corporation.
Trademarks
Epson and Epson Print Image Framer are registered trademarks and Photo
Fine, P.I.F., and Exceed Your Vision are trademarks of Seiko Epson
Corporation.
Epson Store and Epson Connection are service marks of Epson America, Inc.
General notice: Other product names used herein are for identification
purposes only and may be trademarks of their respective owners. Epson
disclaims any and all rights in those marks.
© 2005 Epson America, Inc. 7/05 CPD-20310
P4000Basics.book Page 2 Thursday, August 18, 2005 8:26 AM
3
Contents
Introduction 5
About the Software 6
Replacement Battery 6
Getting Started 7
Unpacking Your P-4000 7
P-4000 Lights and Buttons 8
Installing the Battery 9
Charging the Battery 10
Turning Your P-4000 On and Off 12
Setting the Language, Date, and Time 12
Conserving Battery Power 14
Using the Home Screen 15
Installing the Software 16
Viewing and Playing Photos, Video,
and Music 17
Inserting and Removing Memory Cards 17
Copying Files from a Memory Card 21
Supported File Formats 24
Browsing Files on a Memory Card 26
Using the P-4000 Screen 28
P4000Basics.book Page 3 Thursday, August 18, 2005 8:26 AM
4
Viewing Images 30
Playing Video and Audio Files 35
Copying Files to and From Your Computer 36
Creating Custom Albums and
Slide Shows 39
Creating an Album 39
Creating Custom Slide Shows with Music 45
Showing Photos and Videos on TV 47
Solving Problems 49
Power Problems 49
Viewing Problems 49
File Operation Problems 50
Where To Get Help 51
Appendix 53
Important Safety Instructions 53
FCC Compliance Statement 59
Declaration of Conformity 60
MPEG License Agreement 61
Epson America, Inc. Limited Warranty 62
Index 65
P4000Basics.book Page 4 Thursday, August 18, 2005 8:26 AM
5
Introduction
Your new Epson
®
P-4000 multimedia storage viewer lets
you enjoy photos, videos, and music wherever you go. Its
features include:
Large, high-quality 3.8-inch LCD with Photo Fine
technology
Support for JPEG files and RAW files from select
digital SLR cameras
MP3 and AAC audio
MPEG4 and Motion JPEG video
80GB hard drive
Two slots for CompactFlash
®
and SD
(Secure
Digital) memory cards
Hi-speed USB 2.0 interface for PC or Macintosh
®
Direct printing to select Epson printers
Lithium-ion battery and AC adapter
Video output to display pictures on a TV or
projector
P4000Basics.book Page 5 Thursday, August 18, 2005 8:26 AM
6
About the Software
The CD-ROM that came with your P-4000 includes the
following software for Windows
®
and Macintosh.
Your Epson P-4000 User’s Guide, which has
instructions for all the features of your P-4000,
including printing directly from the P-4000.
A USB driver that lets you transfer files to and from
your computer in Windows 98SE. (If you have a
newer version of Windows or a Macintosh, you dont
need to install the USB driver.)
Adobe
®
Reader
®
to view the P-4000 User’s Guide.
See page 16 for instructions on installing the software.
Replacement Battery
You can purchase a replacement Lithium-ion battery
(B32B818262) from an Epson authorized reseller. To
find the nearest authorized reseller, please call
800-GO-EPSON (800-463-7766). To purchase online,
please visit www.epsonstore.com (U.S. sales only). In
Canada, please call (800) 463-7766 for a reseller referral.
P4000Basics.book Page 6 Thursday, August 18, 2005 8:26 AM
7
Getting Started
Follow the instructions in this section to install the
batteries and software and get ready to use your P-4000.
Unpacking Your P-4000
Epson P-4000
AC adapter and power cord
Viewing stand
Strap
Software CD-ROM
Carrying case
Lithium-ion battery
USB cable
P4000Basics.book Page 7 Thursday, August 18, 2005 8:26 AM
8
P-4000 Lights and Buttons
OK button
Selects an
option, opens a
folder or photo,
and zooms in to
an image.
Access light
Flashes orange
when you turn
on the P-4000
or access files.
Cancel button
Cancels the current
operation and returns to
the previous screen.
4-way ring
Press to select a
photo or an option
in a menu.
Charge light
Turns green
when the battery
is being charged.
Menu button
Displays the
pop-up menu.
Activity light
Flashes blue during power
on, printing, and certain
other operations.
Print button
Displays the Print menu.
Home button
Returns to the
Home screen.
Display button
Displays information,
instructions, or
messages.
P4000Basics.book Page 8 Thursday, August 18, 2005 8:26 AM
9
Installing the Battery
1 Turn the P-4000 upside down.
2 Slide the battery cover to the left to open it.
3 Insert the battery into the compartment with the
gold contacts going in first.
P4000Basics.book Page 9 Thursday, August 18, 2005 8:26 AM
10
4 Close the battery cover and slide it to the right until
it clicks.
Charging the Battery
After installing the battery, you need to charge it using
the AC adapter. When the power is off, it takes about
3 hours to fully charge the battery. With the power on, it
takes longer.
The
Charge light is green while the battery is being
charged. When the battery is fully charged, the light
turns off.
BATT.
P4000Basics.book Page 10 Thursday, August 18, 2005 8:26 AM
11
To charge the battery, connect the AC adapter as shown
below. Connect the other end to the power cord, and
plug it in to an electrical outlet.
Caution:
Do not connect the AC adapter when the battery is not
installed; this can damage the P-4000.
Do not remove the AC adapter while you are using the
P-4000.
The battery status is displayed in the top right corner of
the screen when the P-4000 is on.
:
Battery is fully charged.
:
Battery power is about half full.
:
Battery power is low.
:
Battery power is running out. Charge the battery using the
AC adapter.
:
Battery is charging.
P4000Basics.book Page 11 Thursday, August 18, 2005 8:26 AM
12
Turning Your P-4000 On and Off
To turn on the P-4000, slide the Power switch
down and release it. The blue activity light turns on.
To turn off the P-4000, make sure the
Access light
is off. Then slide the P power switch down and hold
it until the
Access light flashes.
Setting the Language, Date, and Time
When you turn on the P-4000 the first time, you see the
Language setting screen:
Activity
light
Access light
Italiano
Francais
Espanol
Language setting
English (Intl.)
Nederlands
Deutsch
P4000Basics.book Page 12 Thursday, August 18, 2005 8:26 AM
13
1 Press the OK button to select English. You see a
message about setting the date.
2 Press the OK button. You see the Date and time
screen:
3 Press right or left on the 4-way
ring to change the value for the
selected item.
4 To go to the next item, press
down on the 4-way ring. Then
press right or left to change that
setting.
5 After you complete the settings, press the OK button.
You see the Home screen. See page 15 for details.
4-way
ring
P4000Basics.book Page 13 Thursday, August 18, 2005 8:26 AM
14
Note:
If you remove the battery, the date and time settings will be
erased after about one day. The next time you turn on the
P-4000, the date and time setting screen will be displayed. If
you want to change the settings at any time, select Settings
on the Home screen, then select Date and time.
Conserving Battery Power
To conserve battery power and protect the LCD screen,
the P-4000 has two power-saving features. If no button
has been pressed and there has been no activity for 10
minutes, the backlight on the LCD screen is turned off.
After 15 minutes, the power is turned off.
Note:
You can change the number of minutes for these settings;
select Settings on the Home screen, then select Power
Save.
If the screen goes dark because the backlight is
turned off, press any button on the P-4000 to turn it
back on.
If the P-4000 has been powered off, you need to
turn it back on with the P power switch.
Note:
The power is also turned off if the P-4000 gets too hot. If
this happens, let it cool before turning it back on.
P4000Basics.book Page 14 Thursday, August 18, 2005 8:26 AM
15
Using the Home Screen
Whenever you turn on the P-4000, the Home screen
appears. You can return to the Home screen at any time
by pressing the
Home button.
Use the 4-way ring to highlight one of the icons, then
press the
OK button to select it.
Home
Latest Data Settings
Albums Memory CardSaved Data
Battery
status
See page 43 to
create album
shortcuts here
View your
albums
View or copy files
from a memory card
View most
recently
saved files
Customize your
P-4000 and check
storage space
View folders for
all your saved files
P4000Basics.book Page 15 Thursday, August 18, 2005 8:26 AM
16
Installing the Software
Make sure you install the software on your computer
from the CD-ROM that came with the P-4000.
1 Insert the software CD-ROM in your computer’s
CD-ROM or DVD drive.
2 Open the CD-ROM and double-click the Epson
icon if necessary.
You see the license agreement.
3 Read the license agreement, then click Agree.
4 Select your product, then select Install User’s
Guide
.
Enter your administrator name and password if
necessary.
5 If you dont have Adobe Reader on your system, click
Install Adobe Reader to select it.
Enter your administrator name and password if
necessary.
6 When installation is complete, click Exit.
7 When you see the product registration screen,
register your P-4000 as instructed.
P4000Basics.book Page 16 Thursday, August 18, 2005 8:26 AM
17
Viewing and Playing Photos,
Video, and Music
Follow the instructions in this section to insert a memory
card, copy files, and view or play them on your P-4000.
Inserting and Removing Memory Cards
The P-4000 has two memory card slots.
The
C/F Card slot supports the following cards:
CompactFlash, Type I and II
Microdrive
(3.3V only)
The
SD Card slot supports the following cards:
SD card (Secure Digital) up to 512MB
MultiMedia card (MMC V 2.1 or later) up to
512MB
You can also use the following types of memory cards
with a CompactFlash adapter in the
C/F Card slot:
Memory Stick
®
SmartMedia
(3.3 V only)
xD-Picture card
P4000Basics.book Page 17 Thursday, August 18, 2005 8:26 AM
18
Caution:
Never remove a memory card, or shake or drop the P-4000
while the Access light is flashing. Doing so may cause files
to be lost or damaged.
Do not put labels or stickers on memory cards. The sticker
may peel off, preventing the card from being ejected and
damaging the P-4000.
Using the CompactFlash Card Slot
Insert the memory card into the slot with the back of the
card facing the screen. Then push the memory card all
the way into the slot.
Back of card
P4000Basics.book Page 18 Thursday, August 18, 2005 8:26 AM
19
If you are using a CompactFlash adapter, put the card
into the adapter and insert the adapter into the slot.
Caution:
Make sure you insert memory cards in the correct
orientation. Otherwise, the card and P-4000 may be
damaged.
To remove a card from the C/F Card slot, first make sure
the
Access light is off. Then press the eject button and
pull out the card.
If the button is not sticking out, press it once to pop it
out, then press it again to eject the card.
Note:
If you are using a CompactFlash adapter, remove the
adapter from the P-4000; do not remove only the memory
card.
P4000Basics.book Page 19 Thursday, August 18, 2005 8:26 AM
20
Using the Secure Digital Card Slot
Insert the memory card into
the slot with the back of the
card facing the LCD. Then
push the memory card all the
way into the slot.
Caution:
Make sure you insert memory
cards in the correct orientation.
Otherwise, the card and P-4000
may be damaged.
To remove a card from the SD Card slot, first make sure
the
Access light is off. Then press in on the top of the
card. When the card pops out, pull it out of the slot.
Back of card
P4000Basics.book Page 20 Thursday, August 18, 2005 8:26 AM
1 / 1

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Ask the document