SKU#

279-499

INSTALLATION AND CARE GUIDE

ONE-HANDLE LAVATORY FAUCET

Questions, problems, missing parts?

Before returning to the store, call Glacier Bay Customer Service

8 a.m. - 7 p.m., EST, Monday - Friday

9 a.m. - 6 p.m., EST, Saturday

1-855-HD-GLACIER (1-855-434-5224)

Pre-Installation

Warranty

Important Information

Observe all local plumbing and building codes.

Cover the sink drain to avoid losing any parts.

Review the care and cleaning section included in this guide.

Glacier Bay products are manufactured with superior quality standards and workmanship and are backed by our

limited lifetime warranty. Glacier Bay products are warranted to the original consumer purchaser to be free of

defects in materials or workmanship. We will replace FREE OF CHARGE any product or parts that proves defective.

duration of warranty.

Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages, so the

above limitations may not apply to you. This warranty gives you specic legal rights and you may also have other

rights that vary from state to state and province to province. Please see a store or contact 1-855-HD Glacier for

more details.

Before you begin to install this product, ensure that all parts are present. Compare parts with the package

contents list. If any part is missing or damaged, do not attempt to install the product. Contact customer service

for replacement parts.

Adjustable

Wrench

Pre-Installation (continued)

E Lock nut 2

F Deck plate 1

G Gasket 1

H Supply line 2

J Drain ange 1

K Rubber washer 1

HOMEDEPOT.COM/GLACIERBAY

(D) over threaded rods and lift rod (P). Use the

lock nuts (E) to secure the rubber washer (C)

and metal washer (D).

Attach the extension rod (U) to one lock nut

(E), feed a screwdriver (not included) through

the bottom of the extension rod (U), and then

tighten the lock nut (E). Repeat for the second

lock nut (E).

C

(G) and deck plate (F) with the mounting hole in

the sink. Insert the supply lines (H) and the lift

rod (P) through the deck plate (F) and mounting

hole in the sink until faucet (A) sets on top of

deck plate (F).

Clean off the mounting surface.

Installation

1

2

A

WITHOUT DECK PLATE: Insert the supply lines (H)

and lift rod (P) through the mounting hole in the

sink until faucet (A) sets on top of the sink.

Remove the lock nuts (E), metal washer (D), and

rubber washer (C) from the faucet.

9

HOMEDEPOT.COM/GLACIERBAY

be voided.

housing (if applicable).

Ensuring the handle is in the off position, turn

on the water supply and check for leaks. If you

discover any leaks, check your connections to

ensure they are installed properly.

Use a coin to remove the aerator (B) from the

faucet (A). Lift the handle to allow the water to

run for at least one minute. This ushes away any

debris that could cause damage to internal parts.

1

1 Screw A008191

2 Handle Assembly A66E839*

3 Handle Base Assembly A66G052*

4 Locking Nut A104328

5 Ceramic Disc Cartridge A507906N

6 O-ring Sets A608015N

7 Aerator A553019N

13 Cartridge Wrench A031238ZN

14

Allen Wrench

(H2 * 17 mm L * 49 mm L)

A031003NI

15 Extension Rod A031223

*Specify Finish

Service Parts

Many replacement cartridges, aerators, and drain

assemblies can be purchased at your local The