Product assembly
Step 1
Unpack the product (A) and remove all packaging.
Be careful not to scratch the surface of the product whilst removing the
wrapping.
Lay the product out on the floor. If the floor is not carpeted, please cover
it with a soft cloth to avoid damage to the flooring and surface of the
product.
Assembly should take place with the product lying flat.
Step 2
Attach the centre pole onto the lamp holder section by rotating into
place. Ensure the lamp holder section is kept still rotating only the centre
pole. Take care not to allow the electrical cable to twist.
Attach the lower pole section to the centre section by rotating into place.
Ensure the centre section is kept still rotating only the lower pole. Take
care not to allow the electrical cable to twist
Step 3
Insert the pole assembly into the receiving socket on the floor lamp base
ensuring the product is in the intended orientation and facing forwards.
Gently pull any excess cable through the base until the pole is fully
inserted into the socket. Using the Hex key provided tighten the grub-
screws (B) located at the back of the receiving collar to secure the pole
assembly in place. Take care not to overtighten as this may cause damage
to the fitting.
Step 4
Attach the floor cover pad (C) to the underside of the floor lamp base
ensuring it is covered neatly and evenly.
Step 5
Fit the shade glass (D) by first loosening the three thumbscrews attached
to the lamp holder section but do not remove screws fully. Place the
shade glass over the lamp holder until the fluted end of the shade in
contact with the lamp holder. Holding the shade in place, tighten the
screws a little at a time so they secure the glass evenly on all sides. Take
care not to overtighten as this may cause damage to the fitting. Ensure
glass is fully secured before leaving unattended.
Step 6
Stand the floor lamp upright and ensure all the assembled parts are fully
tightened.
Your floor lamp is now ready to be plugged into the wall socket and is
ready to use.