N=
L=
=
Brown or black connect to Brown or Red
Earth
Neutral
Live
INSTALLATION INSTRUCTION
1. Electrical appliances must only be connected by competent persons.
2. Before commencing installation work disconnect the mains cable
from the power supply,removing the fuse or turning switch to "OFF"!
3. Do not attach lamps to surface which are damp,freshly painted,
otherwise eletrically conductive.
4. Use the subjection system according to the weight of the lamp.
5. Be sure to always use the correct type of bulb. (See information
on the label)
6. Cleaning is limited to the outer surfaces, shades or protective
glass, reflectors and covers.
7. Do not touch the bulb with bare hands. Always switch off the
electricity supply and allow to cool for 10 minutes before changing
the light bulbs.
8. If the light is with crystal or glass,please follow below steps.
a. Check the packed bags with numbers then open them.
b. Hang the crystals to the right places according to
the illustration.
NOTES:
1. The symbol " "indicates that the lamp has an earth terminal.
(The earth wire yellow and green )must be connected to the terminal
indicated by the symbol.
2. " "Protection class II=This lamp is doubly insulated and must
not be connected to and earth wire.
3. The symbol" "indicates that the lamp head must be at
least '0.5m' from the lighted surface.
4. The symbol" "indicates that luminaire is suitable for use on
normally flammable surface.
5. The symbol" "indicates that luminaire is only suitable for use
indoors.
6. The below is how fitting wire connect to household circuit.
F
Blue or white connect to Blue or White
Green/Yellow connect to Yellow/Green
Fitting wire colour Household circuit
P28456-72W
Step 1: Step 2:
Step 3:
Fix the ceiling box on
the hanging plate with
screws
Use wire nut to connect all the
wires. Twist wire nuts with the
wires until tightly
joined together.Wrap each
connection with approved
electrical tape and carefully
stuff all the connected wires
into the outlet box.