2. Sprout
  3. MakerWall
MakerWall

Sprout MakerWall User manual

  • I have reviewed the Assembly Instructions for the MakerWall MKA-ROLL Roll Holder. This document provides information on how to assemble the roll holder, including how to attach the brackets, how to insert the dowel, and how to place tape or ribbon on it. I'm ready to answer any questions you may have.
  • What is the first step?
    How many slots wide is a 24 inch roll holder?
    What is the model number for the product?
1
Simple. Modern. American Made.
QUARK ENTERPRISES, LLC PO BOX 1123, PROVO, UT 84601 MODEL NO. MKA-ROLL DOCUMENT: AI-MKA-ROLL WWW.SPROUT-KIDS.COM COPYRIGHT QUARK ENTERPRISES 2022
Adult assembly only
Assemble completely
before use
Insert (1) Bracket a into desired location on
slotboard.
2Insert the other Bracket a into slot the correct
distance away.
3Place grooved end of Dowel b into slots on
Brackets a , as shown.
4To place tape, ribbon, etc onto the dowel, pull one
end up and over as shown.
5Replace the end of the Dowel b into the slot on the
bracket.
ASSEMBLY INSTRUCTIONSPARTS
Frustrated?
Need Help?
STOP
Talk to our customer
service agent at:
+1 (833) 530-0033
MakerWall
Roll Holder
Dowel
(2) Brackets
A
A
A
A
A
A
B
B
24” Roll Holder
= 6 Slots Wide
9” Roll Holder
= 3 Slots Wide
B
B
B
B B
/