2. Computers & electronics
  3. Networking
  4. Networking cables
  5. Simply45
  6. S45-3500B/W Termination

Simply45 S45-3500B/W Termination, S45-3500B Operating instructions

  • Hello! I've reviewed the provided document, which contains instructions for installing the Simply45 Keystone Jack S45-3500B/W. This document provides the steps for stripping the cable jacket, securing the outlet, inserting the cable, and positioning the conductors into the slots, as well as fastening the cable tie. I'm ready to answer your questions about the installation process.
  • How much of the cable jacket should be stripped?
    How should the hinged outlet be secured?
    What should you do after inserting the cable?
    What should you do after positioning the conductors in the slots?
    What is the wiring standard used
Cat5E UTP 180° Keystone Jack 110 Style, Toolless,
w/6 Color ID, 568B Wiring Label, ANSI/TIA 568.2-D,
ISO/IEC 11801 Class D, UL
TERMINATION INSTRUCTIONS
S45-3500B/W
Insert a cable into the termination cap and
fan out all four twisted pairs.
Following the instruction of the color-coded
wire position printed on the termination cap,
position conductors into the slots and make
sure the conductors are in the proper slot.
Trim the ends of the conductors.
1
Install the termination cap to outlet, which
will also allocate the conductors sitting on
the slots.
Secure the hinged outlet by closing
the flaps completely.
Fasten a cable tie wrap to secure
the cable fixture.
2
3
4
5
Cable Fixture
Cable Tie
Strip off 1.6 inch of cable jacket.
1.6"
White/Orange
Orange
White/Green
Green
White/Green
Green
Blue
White/Blue
White/Orange
Orange
White/Brown
Brown
JACK PIN
DESIGNATIONS
1
2
3
6
4
5
7
8
TIA / EIA
T568B
TIA / EIA
T568A
/