- 3 -
CHARGING THE DEVICE
1. Open the DC plug cover.
2. Plug the Charger / AC adaptor into an AC outlet.
3. Connect the Charger / AC adaptor into the device.
4. Charging time is about 2.5 hours.
5. Charging indicator lights:
RED = Charging
GREEN = Fully charged
6. After the device is charged, close the DC plug cover. This will protect the internal electronics from
water damage. NOTE: For optimum performance, please charge this device fully before the first
use.
USAGE GUIDE
1. Turn OFF the power.
2. Attach the telescoping rod if needed: a. Press the fixed button above the telescoping rod to
connect it to the main body. b. Press the length adjustment button to extend or contract the
handle.NOTE: Be careful not to pinch your fingers while attaching the telescoping rod.
3. Attach the appropriate brush or pad for your task.
FOR BRUSHES - align the triangular hole of the brush with the rotating head. Turn the brush in
the clockwise direction indicated to LOCK it into place. To remove the brush, turn it in
the counter-clockwise direction to UNLOCK and remove. See the chart below for suggested
uses.
FOR PADS - first attach the hook and loop fastening pad to the rotating head. Then, attach the
cleaning pad to the hook and loop fastening pad. See the chart below for suggested uses.
4. Turn the device ON.
5. Do not use excessive pressure while cleaning. Allow the device to do the hard work for you.
6. After use, dry off the device and store it on the plastic base. Dry off the brushes and pads to
prevent mold and mildew. NOTE: To avoid electric shock, so not allow the Charger / AC adaptor to
come into contact with water.
BRUSH AND PAD GUIDE
ATTACHMENT SUGGESTED USES
Hard floor brush Bathroom, uneven tile floors, rough floors,
balcony
Long bristle brush Toilet, car tires, deep, hard-to-reach areas
Hook & loop pad + Scouring pad Smooth tiles, sink, bathtub
Hook & loop pad + Sponge pad Cars, windows, glass and other delicate
surfaces
Hook & loop pad + Cotton flannel pad Bathtub, ceramic and other smooth surfaces,
wood floors
NOTE: This device has a waterproof design. It can be submerged up to 3 feet of water for up to
30 minutes. If it is submerged deeper or longer than recommended, the device may be
damaged. Please be sure the DC plug cover is closed to protect the electronic components
inside.