Unbranded EN15012068E680 User manual

Brand: Unbranded

Model: EN15012068E680

Type: User manual

© 2018 Trinity Glass International, Inc.

DOCXXXXXXXX 06/18

Interior Door

Finishing Care

1

Preparing Your New Door For Finishing

1. Mask or remove any hardware (hinges,

handles, etc.). Mask glass if applicable before

painting or staining.

2. Sand the entire surface lightly using 5/0

sandpaper (180 grit) before you apply first coat

of finish. Always sand in the direction of the

wood grain, see Figure 1.

3. Wipe dust and sand grit from the door with

clean cloth. Avoid using abrasive or caustic

cleaners.

Painting Primed Door

1. Complete steps 1-3 for Preparing Your New Door For

Finishing. Although primed door does not require

sanding prior to finishing, light sanding (180 grit) will

allow for optimum adhesion of paint.

2. Finish the door with two coats of latex, oil-base or

lacquer paint. Make sure to allow door to completely dry

between coats on all six sides of door. Always paint in

the direction of the wood grain, see Figure 1.

Figure 1

Note – Always follow the stain

manufacturer’s instructions.

Finishing Instructions

Follow instructions here on finishing your new Feather

River Interior Door. Remember to finish all six sides

and follow the appropriate instructions below based on

your desired finish type.

Staining/Finishing Your Wood Door

1. Complete steps 1-3 for Preparing Your New Door For

Finishing. Apply a base coat of presealer on all six sides

of door before staining. This is especially important on

pine and maple doors.

2. Stain door to desired color following stain

manufacturer’s instructions. Always stain in the direction

of the wood grain, see Figure 1.

3. For best results, apply at least two clear top coats over

stain, sanding lightly between coats. Use 6/0 (220 grit)

or finer sandpaper. Make sure that stain and top coat

are compatible materials.

Care and Maintenance

• Clean glass regularly or as needed

• Each year try to wipe down your doors to remove

any dust or debris buildup

• Finishing wear: Re-paint or top coat (stained doors)

as you notice slight fading or wear on your original

finish applied

1

Unbranded EN15012068E680 User manual

Brand: Unbranded

Model: EN15012068E680

Type: User manual

Download PDF

Related papers

Other documents