Generation Lighting VS23403 Installation guide

Type
Installation guide
1
Installation Instructions for
Secure the mounting plate to the junction box.
Install the shade to the shade base and secure it in place using the thumb screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the set screw using an Allen wrench.
1
2
3
4
5
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Hooper Wall
1.0
VS23401-VS23402-V 23403S
V 23401, VS23402, V 23403SS
Wall
1A
JUNCTION BOX
MOUNTING
PLATE
5
ALLEN WRENCH
6
SET SCREW
7
6
7
SHADE
LAMP
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
3
SHADE BASE
THUMB SCREW
2
SAVETHESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.Feiss.com
© 2017 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Generation Lighting VS23403 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI